setting up your washing machine
6. Turn on the water supply and ensure that no water leaks | |
from the water valve, tap or adaptor. If there is a water | |
leaks, repeat the previous steps. | |
Do not use your washing machine if there is a water leak. | |
WARNING This may cause electric shock or injury. | |
|
•If the water tap has a screw type tap, connect the water supply hose to the tap as shown.
Use the most conventional type of tap for the water supply. In case the tap is square or too big, remove the spacing ring before inserting the tap into the adaptor.
Connecting the drain hose
1.Press the catches of the clamp and insert the drain hose into the clamp.
•Insert the drain hose into the drain hole (A) and push the hose connector firmly into the drain hole while pressing the catches of the clamp and then release the catches to fix the drain hose connector.
TYPE 1 | TYPE 2 |
drain | drain |
hole (A) | |
| hole (A) |
2.Fasten the 4 screws of the drain hose connector and make sure that they are level.
• Failing to do so may result in water or bubbles leaking while the water is drained.
•Place the drain hose lower than the drain hole (B) and do not extend the hose longer than 3 m. Otherwise, draining water may fail. (To extend the drain hose, ask for assistance from an authorized installation or service engineer.)
The drain outlet of the washer may be on the left or right depending on the model.
drain hose connector
drain hole (B)
English - 22