Sanyo dsr-3706pa bNetwork Connection Restrictions, bChange to DVR Operation

Network Connection Procedure

bNetwork Connection Restrictions

Connections are restricted depending on the connections state of users and the content of the network settings. If a DVR cannot be connected, confirm whether the connection falls under the following restrictions.

Restrictions on the number of simultaneous connected users

There is a limit to the number of users who can connect simultaneously.

When a connection is not possible due to restrictions on the number of simultaneous connections, the message "THE UNIT IS BUSY!" will display.

1Up to four users can connect simultaneously to one DVR.

2Only one user of either ID2 or ID3 can connect.

3When a connection is duplicated, the user with the higher user level will take precedence.

Example:

•If an ID1 user attempts to connect at the same time as four other ID1 users, the connection will not be allowed.

•If an ID2 user attempts to connect at the same time as four other ID1 users, the ID1 user who connected last will be disconnected and the ID2 user will be allowed to connect in the ID1 users' place.

•If an ID3 user attempts to connect at the same time as three other ID1 user and an ID2 user, since ID2 and ID3 users are not able to connect simultaneously, the ID2 user will be disconnected and the ID3 user will be allowed to connect in the ID2 user's place.

Restrictions determined by network settings

Connection is restricted by the [NETWORK CONTROL] settings of NETWORK SET of the DVR.

When a connection is not possible due to operation restrictions established by NETWORK SET or the operating state of the DVR, the message "THE UNIT IS NOT READY!" will display.

1When "ON (NETWORK)" is selected.

•All users (ID1 to ID3) can connect.

•Cannot connect during DVR playback, camera control, and while displaying menu screens.

2When "ON (DVR)" is selected.

•Only user level ID1 can connect. Only monitoring of live video on the computer is possible.

•Cannot connect while the DVR is in playback operation.

•If the playback operation is performed by the DVR when connected, the connection will be automatically disconnected.

3When "OFF" is selected. Cannot connect to DVR.

bChange to DVR Operation

If the disconnect button on the operation panel is clicked, the network connection will disconnect and the DVR can be operated.

When the connection is disconnected, the message "THE UNIT IS DISCONNECTED!" will display.

Disconnect

button

•If the browser is closed without clicking the disconnect button, approximately 1 minute will pass until reconnecting.

•When [NETWORK CONTROL] of NETWORK SET of the DVR is set to "ON (NETWORK)", press the [EXIT/OSD] button for at least 2 seconds. The connection can be forcibly disconnected from the DVR. The connection will not be accepted from the computer for 10 seconds after a forced disconnect.

EXIT/OSD

•When communication with the computer is cut off for approximately 1 minute or more, the connection will automatically disconnect and switch to DVR operation.

•The connection will automatically disconnect when the settings of NETWORK SET of the DVR are changed while connected.

6 English