Sanyo PLC-XL50A owner manual Part Names and Functions Rear Terminal

Part Names and Functions

Rear Terminal

q w e r t

yu

qAUDIO IN

Connect the audio output from video equipment connected to w, t or y to this jack. [When the audio output is monaural, connect it to L (MONO) jack (p.17-18).

wVIDEO IN

Connect the composite video output from video equipment to VIDEO jack (p.17).

eAUDIO IN COMPUTER

Connect the audio output (stereo) from a computer connected to u or i to this jack (pp.16, 18).

rAUDIO OUT(VARIABLE)

Connect an external audio amplifier to this jack (pp.16 – 18).

This terminal outputs sound from AUDIO IN terminal (q or e).

tS-VIDEO IN

Connect the S-VIDEO output from video equipment to this jack (p.17).

io

yCOMPONENT IN

Connect the component video output signal to these jacks (p.18).

uCOMPUTER IN 2/MONITOR OUT

This terminal is switchable and can be used for input from a computer or output to the other monitor.

Set the terminal up as either Computer input or Monitor output properly. [Used for Monitor out, this terminal outputs only incoming signal from COMPUTER IN 1 terminal (pp. 16, 49).

i COMPUTER IN 1

Connect output signal from a computer, or RGB scart 21-pin video output to this terminal (pp.16, 18).

When the cable is of the longer variety, it is advisable to use this terminal and not COMPUTER IN 2/MONITOR OUT.

oSERVICE PORT

This jack is used to service the projector. When controlling the projector with RS-232C, connect the control equipment to this connector with the serial control cable.

10