Sanyo PLC-XL50A Maintenance and Cleaning Cleaning the Air Filter, Resetting the Filter Counter

Maintenance and Cleaning

Cleaning the Air Filter

The air filter prevents dust from accumulating on the surface of the optical elements inside the projector. Should the air filter become clogged with dust particles, it will reduce cooling fans’ effectiveness and may result in a buildup of internal heat and adversely affects the life of the projector. Clean the air filter by following the steps below.

1	Turn off the projector, and unplug the AC power cord
	from the AC outlet.
2	Turn over the projector and remove the air filter by
	pulling the latches upward.
3	Clean up the dust on the projector and around the air
	vents.
4	Gently clean the filter by using a brush or blower.
	WARNING: Do not wash the filter with water and
	any other liquid matter. Otherwise the filter may
	be damaged.
5	Reinstall the filter into the projector properly.
6	Reset the filter counter in the Setting Menu. See
	“Resetting the Filter Counter” below.

CAUTION

Do not operate the projector with the air filter removed. Dust may accumulate on the optical elements degrading picture quality. Do not put anything into the air intake vents. Otherwise it may result in malfunction of the projector.

Air filter

Pull up the tab and remove.

✔Note:

•When cleaning the air filter, protect the infrared remote receiver with a soft cloth to avoid damaging it.

•If the filter is heavily clogged and unable to clean, replace it with a new one. Consult your dealer for details.

Replacement Filter Part No.: 610 335 4057

RECOMMENDATION

We recommend avoiding dusty/smoky environments when you operate the projector. Usage in these environments may cause poor image quality.

When you use the projector under dusty or smoky conditions, dust may accumulate on the lens, LCD panels, or optical elements inside the projector degrading the quality of a projected image.

When the symptoms above are noticed, contact your authorized dealer or service station for proper cleaning.

Resetting the Filter Counter

Be sure to reset the Filter counter after cleaning or replacing the filter.

1	Filter counter
	Press the MENU button to display the On-Screen
	Menu. Use the Point 7 8 buttons to move the red
	frame pointer to the Setting Menu icon.
2	Use the Point ed buttons to move the red frame
	pointer to Filter counter and then press the SELECT
	button. A dialog box appears showing the total
	accumulated time of the filter use, a timer setting
	option, and the reset option. Select Reset and the
	“Filter counter Reset?” appears. Select [Yes] to
	continue.
3	Another confirmation dialog box appears, select [Yes]
	to reset the Filter counter.

Select Reset and the “Filter counter Reset?” appears.

Select [Yes], then another confirmation box appears.

Select [Yes] again to reset the Filter counter.

56