Setting
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the input signal is interrupted and no button is pressed for a certain period.
When the input signal is interrupted and no button is pressed for more than 30 seconds, the timer display with “No signal” appears. The countdown starts to turn off the lamp.
Select one of the operations.
Ready………When the lamp has been fully cooled
down, the POWER indicator changes to green blinking. In this condition, the projection lamp is turned on if the input signal is reconnected or any button on the remote control is pressed.
Shut down…When the lamp has been fully cooled down, the power is turned off.
Off………… Power management function is off.
Then set the countdown timer with the Point 7 8 buttons.
✔Note:
• Factory default is “Ready: 5 min.”
On start
When this function is set to “On,” the projector is automatically turned on just by connecting the AC power cord to an outlet.
✔Note:
•Be sure to turn the projector off properly (see “Turning Off the Projector” on page 21). If the projector is turned off in the incorrect sequence, the On start function does not operate properly.
Lamp control
You can change the brightness of the screen.
Normal … Normal brightness
Auto …… Brightness according with the input signal
Eco …… Lower brightness reduces the lamp power
consumption and extends the lamp life.
Power management
Time left before Lamp is off.
Press the SELECT button at Power management and this box appears. Select one of three settings with the Point 7 8 buttons, and go to the timer with the Point ed buttons and set time with the Point 7 8 buttons.
On start
50
