Video Input
Input Source Selection (RGB Scart 21-pin)
Direct Operation
Press the INPUT button on the top control or COMPUTER button on the remote control to select Computer 1. Before using INPUT or COMPUTER buttons, select the correct input source through Menu operation as described below.
Menu Operation
1 | Use the MENU button to display the |
| Press the Point 7 8 buttons to move the red frame |
| pointer to the Input Menu icon. |
2 | Use the Point ed buttons to move the red arrow |
| pointer to Computer 1 and then press the SELECT |
| button. |
3 | After the Source Select Menu appeared for Computer |
| 1, move the pointer to RGB (Scart) and then press the |
SELECT button.
Top Control
INPUT button
INPUT button
Video
Computer 1
Computer 2*
Remote Control
COMPUTER button
/
COMPUTER button
Computer 1
Computer 2*
*See Note at the bottom of this page.
RGB (Scart)
✔Note:
When the input source is coming from video equipment connected to the COMPUTER IN 1 terminal with a
Input Menu | Input Menu icon | ||
|
|
| Move the pointer (red arrow) |
|
|
| to Computer 1 and press the |
|
|
| SELECT button. |
|
|
| |
|
|
|
|
| Computer |
| |
1 |
|
| |
|
|
| Source Select Menu |
|
|
| Move the pointer to RGB (Scart) |
|
|
| and press the SELECT button. |
•Computer 2 is not displayed when the COMPUTER IN 2/ MONITOR OUT terminal is set as Monitor out (p.49). •Computer 2 (COMPUTER IN 2/MONITOR OUT) can accept only RGB signal.
•When the Input Search function is set On1 or On2, the input signal will be searched automatically (p.49)
38
