Sanyo PLC-XU84 Appendix, Some displays are not seen during the operation, be selected, not work

Appendix

Some displays are not seen during the operation.

– Check the Display function. See page 46.

PIN code dialog box appears at start-up.

–PIN code lock is being set. Enter a PIN code (the “1234” or numbers you have set). See pages 21, 52–53.

Computer 2 cannot be selected.	– Select Computer 2 at the Terminal function. (See page 49.)
The Terminal function cannot	– The Terminal function cannot be selected after Computer 2 is
be selected.	selected. Select other input source such as Computer 1 or
	Video with the INPUT button on the top control, the
	COMPUTER button or the VIDEO button on the remote
	control so that the Terminal function can be selected.
The Remote Control does	– Check the batteries.
not work.	– Make sure no obstruction is between the projector and remote
	control.
	– Make sure you are not too far from the projector when using the
	remote control. Maximum operating range is 16.4’ (5 m).
	– Make sure the code of the remote control is conformed to the
	projector’s code. See page 51.
	– Unlock the Key lock function for the remote control function. See
	page 52.
	– Check RESET/ON/ALL-OFF switch on the remote control is set to
	“ON”. See page 12.

WARNING :

High voltages are used to operate this projector. Do not attempt to open the cabinet.

If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or the service center. Specify the model number and explain about the problem. We will advise you how to obtain service.

The CE Mark is a Directive conformity mark of the European Community (EC).

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.

Pixelworks ICs used.

63