OUTPUT TERMINALS
REMOTE Jack
You can use a
NOTE:
•The functions not available on the VCR will not operate.
Remote control of the VCR is possible by connecting a remote controller with a circuit such as indicated below, to the REMOTE jack.
NOTES:
•Use a 3.5 mm
•The connection should be done using a shielded cable no more than 5 meters long.
•The functions not available on the VCR will not operate.
Remote control circuit
The remote control switch 7 can be set to either eject the tape or access the menus.
1Press the MENU button until the (SET UP 5) menu is displayed.
@@@@@@@<SET@UP@5>
*INPUT@OUTPUT@ALARM
*OUTPUT@@@@@@@SERIES
*WARN.@OUT@@@@TRANSPORT
*REMOTE@@@@@@@EJECT
2Press the ] button, until the “REMOTE” setting is flashing.
3Press the l (or j) button to select the desired switch mode.
EJECT . . . . . . Switch 7 will eject the tape.
MENU. . . . . . . Switch 7 will display the menu.
4Press the PAUSE/SEARCH button to save the setting.
R0 1.2K
R1 0.3K
SW0: EJECT
SW1: STOP
COM Terminal
•Common GND (ground) terminal when connecting other terminals to external devices.
R2 0.43K
R3 0.51K
R4 0.62K
R5 0.75K
R6 0.91K
SW2: PAUSE/SEARCH
SW3: REW
SW4: FF
SW5: PLAY
SW6: REC
R7 1.1K
R8 1.3K
R9 2.0K
SW7: EJECT (or MENU)
SW8: Do not use
SW9: TIMER, j
R10 2.4K
R11 3.6K
R12 5.6K
SW10: REC/PLAY SPEED CHANGE, l
SW11: TRACKING V.STILL
SW12: TRACKING V.STILL +, «
The resistance tolerance is 2% or less.
42 | English |