NORMAL RECORDING

Setting the Mode at the End of the Tape

In the (SET UP 3) menu, you can set the mode of the VCR mode when the tape reaches the end during recording.

1Press the MENU button until the (SET UP 3) menu is displayed.

@@@@@@@<SET@UP@3>

*ALARM@MODE@@@@@@@Y1

*ALARM@SPEED@@@@@@8H

*ALARM@DURATION@@@20S

*VERTICAL@SYNC@@@@Y

*EXT@TIME@ADJ.@@@@01:00

*TAPE@IN@MODE@@@@@STOP

*TAPE@END@MODE@@@@REW *TAPE@END@OUT@@@@@-3M *CLOG@DETECT.@@@@@Y *SERIES@REC@IN@@@@N

2Press the ] button, until the “TAPE END MODE” setting is flashing.

3Press the l (or j) button to set the desired mode.

•Setting when not using Autorepeat recording

REW . . . . . . .

Rewinds the tape to the

 

beginning, then goes to stop mode

STOP . . . . . . .

Goes to stop mode

EJECT . . . . . .

The cassette is ejected

•Setting when using Autorepeat recording

R1 . . . . . . . . . Autorepeat recording mode is automatically canceled if there was an alarm trigger

R2 . . . . . . . . . Autorepeat recording mode is active even if there was an alarm trigger

4Press the PAUSE/SEARCH button to save the setting.

Tape Counter Notes:

•There is no tape counter indication for the blank portions of the tape.

•In the 8-hour recording speed mode only, the tape counter indicates real hours, minutes and seconds.

•In the other recording speed modes, the tape counter indication is a ratio of the 8-hour mode base indication. (In 40-hour recording mode, each “second” of the tape counter actually represents approximately 40/8 = 5 real seconds.)

•There may be a slight discrepancy between the position shown on the tape counter and the actual tape position.

•When rewinding the tape past the “0:00:00” position, a minus (–) sign will be displayed.

22

English