NU4QG/NA3
TAPE MANAGEMENT FUNCTION
This VCR is equipped with a tape management function. Using this function you can protect previous recordings and prevent overuse of the tape by controlling the tape protection term (number of days), the maximum number of
PROTECT DAY: To set the number of days before the tape can be rerecorded over.
REC PASS SET: To limit the number of rerecordings, in order to maintain a good image quality.
GROUP NO.: | To manage tapes belonging to different |
| recording groups. |
NOTE:
•Before using this function, make sure that the clock is set properly.
Operation
When recording is started, the VCR will rewind the tape to the beginning, and will playback some of the tape to check for the presence of tape management data (no image is displayed). While the presence and type of data are checked, the message “T. MANAGE. CHK” is displayed
NOTES:
•When a program timer recording is set, the tape management data is checked after the TIMER button is pressed to complete the program timer recording setting.
•During alarm recording, the tape management function will not operate even if it is active.
If no tape management data is present on the tape
Recording will start according to the settings in the (TAPE MANAGEMENT) menu.
When recording starts, the updated tape management data is recorded onto the tape.
If the tape has already been recorded on, the message “USED TAPE” will flash
If tape management data is present on the tape
The tape management data is checked and if there is no conflict, the VCR will rewind the tape to the beginning, then recording starts and the updated tape management data is recorded onto the tape. While the tape is rewound and the tape management data recorded, the message “T. MANAGE. OK” is displayed
If a conflict is found when the tape management data is checked, the (TAPE MANAGEMENT) menu is displayed and the conflicting setting will flash. This menu will show the settings taken from the data recorded on the tape and not the current data settings held in the VCR’s (TAPE MANAGEMENT) menu setting. Refer to “Tape Management Conflict Display” for detailed information.
NOTES:
•During Autorepeat recording, the tape management data at the beginning of the tape will be checked and updated every time the tape is rewound to the beginning. However, the “PROTECT DAY” setting will be ignored. Also, even if there is a conflict with the “REC PASS SET” number, autorepeat recording will continue without any warning.
•If the VCR is set for alarm recordings, alarm recording will be done based on the different settings.
If an alarm trigger is received while the tape is being first rewound, the tape will continue to be rewound to the beginning, then alarm recording will be done after the tape has been advanced of a preset duration.
If an alarm trigger is received while the message “T. MANAGE. CHK” is displayed
If an alarm trigger is received while tape management data is being recorded onto the tape, alarm recording will only start after all the data has been recorded.
Furthermore, when setting a program timer recording, in order to protect the data, no alarm trigger will be received until the first program timer recording starts.
IMPORTANT NOTES:
•If the tape management data cannot be read, the VCR will switch to stop mode and “INCORRECT DATA” will be displayed
This may indicate that the beginning of the tape (data recording/reading section) is damaged and the tape may be unusable.
The message “INCORRECT DATA” will disappear when the EJECT, STOP or PLAY button is pressed.
•Set the security lock function to on in order to protect the security of this feature.
16 | English |
