NU4QG/NA3 (SRT-2400DC GB) Mon. Sept., 17/2001

OUTPUT TERMINALS

REMOTE Jack

You can use a VA-RMN01 Remote Control Unit (sold separately) to control remotely the VCR.

NOTE:

The functions not available on the VCR will not operate.

Remote control of the VCR is possible by connecting a remote controller with a circuit such as indicated below, to the REMOTE jack.

NOTES:

Use a 3.5 mm mini-jack type plug.

The connection should be done using a shielded cable no more than 5 meters long.

The functions not available on the VCR will not operate.

Remote control setting

The remote control switch 7 can be set to either eject the tape or access the menus.

1Press the MENU button until the (SET UP 5) menu is displayed.

@@@@@@@<SET@UP@5>

*INPUT@OUTPUT@ALARM

*OUTPUT@@@@@@@SERIES

*WARN.@OUT@@@@TRANSPORT

*REMOTE@@@@@@@EJECT *TAPE@@@@@@@@@T-160

2Press the ] button, until the “REMOTE” setting is flashing.

3Press the l (or j) button to select the desired switch mode.

EJECT . . . . . . Switch 7 will eject the tape.

Remote control circuit

R0 1.2K

R1 0.3K

R2 0.43K

R3 0.51K

R4 0.62K

R5 0.75K

R6 0.91K

R7 1.1K

R8 1.3K

R9 2.0K

R10 2.4K

R11 3.6K

R12 5.6K

The resistance tolerance is 2% or less.

SW0: EJECT

SW1: STOP

SW2: PAUSE/SEARCH

SW3: REW

SW4: FF

SW5: PLAY

SW6: REC

SW7: EJECT (or MENU)

SW8: Do not use

SW9: TIMER, j

SW10: REC/PLAY SPEED CHANGE, l

SW11: TRACKING V.STILL – , ]

SW12: TRACKING V.STILL +, «

MENU. . . . . . . Switch 7 will display the menu.

4Press the PAUSE/SEARCH button to save the setting.

COM Terminal

Common GND (ground) terminal when connecting other terminals to external devices.

42

English

Page 43
Image 43
Sanyo SRT-2400DC instruction manual Remote Jack, COM Terminal, Remote control setting