NU4QG/NA3
OUTPUT TERMINALS
SERIES OUT/NON REC OUT terminal setting
The output at the SERIES OUT/NON REC OUT terminal can be set.
1Press the MENU button until the (SET UP 5) menu is displayed.
NOTE:
•If “OUTPUT” is set to “NON REC”, the “NON REC OUT” line will be displayed under the “OUTPUT” line.
@@@@@@@<SET@UP@5>
*INPUT@OUTPUT@ALARM
*OUTPUT@@@@@@@SERIES
*NON@REC@OUT@@ACTIVE@LOW
*WARN.@OUT@@@@TRANSPORT
*REMOTE@@@@@@@EJECT
2Press the ] button, until the “OUTPUT” setting is flashing.
3Press the l (or j) button, to select the desired output mode.
SERIES . . . . . The SERIES OUT/NON REC OUT terminal will be set to
SERIES OUT.
If during series recording, the counter reading reaches 7:57:00 or the tape reaches the end, a LOW signal (0 V) is output. The LOW (0 V) signal is output for about 70 seconds after the end of the tape is reached.
NON REC . . . The SERIES OUT/NON REC OUT terminal will be set to NON REC OUT.
If “OUTPUT” is set to “NON REC”, please continue with step 4.
4Press the ] button.
5Press the l (or j) button to select the desired output.
ACTIVE LOW . . Normally DC 5V are output between the SERIES OUT/NON REC OUT and the COM terminals. If during recording the VCR enters a mode other than recording (i.e. recording pause, stop mode, etc.), the output become 0 V (Low). If recording is resumed, then the output become 5 V (High).
ACTIVE HIGH . . Normally 0V are output between the SERIES OUT/NON REC OUT and the COM terminals. If during recording the VCR enters a mode other than recording (i.e. recording pause, stop mode, etc.), the output become 5 V (High). If recording is resumed, then the output become 0 V (Low).
NOTES:
•If “NON REC OUT” is set to “ACTIVE HIGH”, a throwaway pulse will be output from the SERIES OUT/NON REC OUT terminal when power is restored after an outage, when the power is turned on or when the ALL RESET button is pressed. This will continue until the microprocessor starts operating. If this output terminal is connected to some other device, the device should be set or adjusted so that it is not affected by the throwaway pulse. If set to “ACTIVE LOW”, this kind of pulse is not output, and so it is recommended that you use the “ACTIVE LOW” setting.
•If in the (SET UP 2) menu, in the “BUZZER” section, “WARNING” is set to “Y”, a buzzer will be heard while the VCR is in non recording mode. The buzzer will stop if the STOP button is pressed (the output signal will remain).
6Press the PAUSE/SEARCH button to save the setting.
ALARM IN/CLOCK IN and ALARM OUT/CLOCK OUT terminal setting
1Press the MENU button until the (SET UP 5) menu is displayed.
°The “INPUT OUTPUT” setting is flashing.
2Press the l (or j) button to select desired input/output mode.
ALARM. . . . . . The ALARM IN/CLOCK IN terminal is set to ALARM IN and the ALARM OUT/CLOCK OUT terminal is set to ALARM OUT.
CLOCK SET. . The ALARM IN/CLOCK IN terminal is set to CLOCK IN and the ALARM OUT/CLOCK OUT terminal is set to CLOCK OUT.
3Press the PAUSE/SEARCH button to save the setting.
English | 41 |
