Alarm Settings (ALARM)
3Use the joystick lever (xy) to select [POSITION] – “SET y”, and press the [ENTER] button.
The AREA screen for setting surveillance area appears. In this screen, while panning or tilting the camera, set the surveillance area to detect movement.
AREA 1
4Use the joystick lever to perform panning or tilting, and press the [ENTER] button.
The POSITION screen appears displaying the detection pattern (in smallest size) in the center of the screen. In this screen, determine the position of the detection pattern.
POSITION
SET y
5Use the joystick lever to move the detection pattern to your desired position, and press the [ENTER] button.
Move the detection pattern so that the pattern is located at the top left corner of the surveillance area.
Pressing the [ENTER] button displays the SIZE screen. In this screen, determine the size of the detection pattern.
SIZE
SET y
6Use the joystick lever to adjust the size of the detection pattern, and press the [ENTER] button.
Originating from the position of the detection pattern specified in the POSITION screen, the joystick lever (y) expands the pattern downward and the lever (w) expands the pattern to the right.
SIZE
SET y
After pressing the [ENTER] button, the AREA setting menu appears again.
7Use the joystick lever (xy) to select [DISPLAY] and use the lever (vw) to select “ON/OFF”.
Select whether the surveillance area specified in the AREA screen is displayed on the monitor screen or not.
Available settings:
•OFF: Does not display the surveillance area.
•ON: Displays the surveillance area.
8To continue setting other surveillance area (2 - 4):
After returning to the MOTION ZONE screen, repeat the same procedure (Steps 2 to 7).
bSetting the detection sensitivity
You can set the level of sensitivity for motion detection. Adjusting the level of sensitivity avoids unwanted detection.
To set the detection sensitivity, perform the following procedure in the MOTION ZONE screen.
1Use the joystick lever (xy) to select [SENSITIVITY]
– “SET y”, and press the [ENTER] button.
The SENSITIVITY screen appears.
Set the detection level for the following parameters. For all parameters, the larger the value, the lower the sensitivity.
SENSITIVITY |
|
|
|
|
|
|
| a | ||||
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
| b | |||||
MOVE |
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
| |||||
|
| 5 | ||||||||||
|
| 5 |
|
|
|
|
| c | ||||
|
|
|
|
|
|
| ||||||
| 5 |
|
|
|
|
| d | |||||
DURATION |
|
|
| 1 |
|
|
|
|
| |||
|
|
|
|
|
|
|
| |||||
TEST |
|
| OFF |
|
|
|
|
|
| |||
|
|
|
|
|
|
| ||||||
aMotion sensitivity (MOVE): 1 - 10
To avoid detection of small movements, make the value larger.
bBrightness level
When noise from a dark screen is causing erroneous detections, make the value larger.
cBrightness differences
To avoid detection of lights turning on and off, make the value larger.
dDuration (DURATION): 1 - 60
To avoid detection of fast movements, make the value larger.
2To test the sensitivity settings, use the joystick lever (xy) to select [TEST] and use the lever (vw) to select a surveillance area number (1 - 4).
You can test the detection sensitivity for the specified surveillance area.
When a motion is detected, patterns are shown in that location. Adjust the setting values as necessary.
42