Sanyo VCC-MC500P, VCC-MC600P Setting the alarm information display, E (ALARM DISPLAY)

Alarm Settings (ALARM)

Setting the alarm signal output

Set the alarm output options for the alarm detection in the surveillance area (AREA 1 - 4).

After returning to the MOTION ZONE screen, perform the following procedure.

MOTION ZONE
AREA 1	OFF
AREA 2	OFF
AREA 3	OFF
AREA 4	OFF
SENSITIVITY	SET y
ALARM OUT	OFF
LINE OUT	OFF
DURATION	5S
PRESET	OFF
MENU	BACK

1Use the joystick lever (xy) to select [ALARM OUT] and use the lever (vw) to select an alarm output terminal.

Available settings:

•OFF: Does not output the alarm signal.

•1: Uses the output terminal 1.

•2: Uses the output terminal 2.

2Use the joystick lever (xy) to select [LINE OUT] and use the lever (vw) to determine whether the alarm signal is output to the connection line with the system controller.

Available settings:

•OFF: Does not output the alarm signal to the connection line.

•ON: Outputs the alarm signal to the connection line.

3Use the joystick lever (xy) to select [DURATION] and use the lever (vw) to select the interval after which the next alarm becomes in effect.

Available settings: 5S, 10S, 15S, 20S, 30S, 45S, 1M, 2M, 3M, 4M, 5M (S: Second, M: Minute)

☞After completing setting, use the lever to move the cursor to [MENU] and select “BACK” or “END”.

Setting the alarm information display

E (ALARM DISPLAY)

When the alarm is detected, the preset number and the camera ID on the screen flash notifying that the alarm is detected.

Monitor display legend

001 CAM1 FLOOR

	ALARM
ALARM	IN	1	y
ALARM	OUT	1	y
ALARM	DISABLE	ON
TIME		1M
MOTION		PRESET
ALARM	DISPLAY	ON
TIME		5S
PRESET		OFF
MENU		BACK

1Use the joystick lever (xy) to select [ALARM DISPLAY] and use the lever (vw) to select “ON/OFF”.

Available settings:

•OFF: The alarm information does not flash.

•ON: The alarm information flashes.

([TIME] appears under [ALARM DISPLAY].)

2When “ON” is selected, use the joystick lever (xy) to select [TIME], and use the lever (vw) to select the duration for which the alarm information is flashing.

Available settings: 5S, 10S, 15S, 20S, 30S, 45S, 1M, 2M, 3M, 4M, 5M (S: Second, M: Minute)

☞After completing setting, use the lever to move the cursor to [MENU] and select “BACK” or “END”.

43