SATO CX Series - page 26

SATO CX Series Printer

Printer Output:

Special Notes

1. Use of this command will set the Vertical/Horizontal Off-

set setting of the printer configuration until a new Base

Reference Point command is issued.

2. This command may be used more than once in a print

job.

3. An alternative to using this command is to make chan-

ges to your current Horizontal and Vertical Print Position

commands (See page 57).

Example:

Let’s say the current base reference point is H=1, V=1 and

you wish to move all the fields on your label downward ver-

tically by 150 dots. You could either (1) add the Base Refe-

rence Point command or (2) change all the vertical position

commands by an additional 150 dots.

4. For a more detailed example of the Base Refere nce Point

command, see “Print Area” in this section(See page 5).

5. The CX Ser ies pr inter s will not “w rap” (i .e. if any pa rt of a

character or image extends beyond the last print dot

position, it will disappear and not be visible on any part

of the label).