Section 4. Programming Reference

Special Notes

1.

Use of this command will set the Vertical/Horizontal Offset setting of

 

 

the printer configuration until a new Base Reference Point

 

 

command is issued or the setting is changed from the operator

 

 

panel. See Section 2: Printer Configuration.

 

2.

This command may be used more than once in a print job.

 

3.

An alternative to using this command is to make changes to your

 

 

current Horizontal and Vertical Print Position commands (see

 

 

Page 4-59).

 

Example:

 

 

Let’s say the current base reference point is H=1, V=1 and you

 

 

wish to move all the fields on your label downward vertically by

 

 

150 dots. You could either (1) add the Base Reference Point

 

 

command or (2) change all the vertical position commands by an

 

 

additional 150 dots.

 

4.

For a more detailed example of the Base Reference Point

 

 

command, see “Print Area” in this section (Page 4-4).

 

5.

The allowable field ranges for this command are:

Horizontal

aaaa

Vertical

bbbb

M-8400RV

-0832 to 0832

0001 to 1424

Page 4-20

9001041 Rev. D

SATO M-8400RV

Page 82
Image 82
SATO M-8400RV manual Printer configuration until a new Base Reference Point, Panel. See Printer Configuration