Copy Settings
Partial Copying
The Partial Copy function copies only a part of an original.
You need to enter start and end points in the feed direction of the original .
3
Note
❒You cannot use the Partial Copying function when using the Rear Table.
❒You cannot use the Partial Copying function for originals shorter than 150mm.
❒You can use the Partial Copying function for originals longer than 1270mm.
❒If you set the start point within 130 mm of the leading edge of the original, the copier will regard the leading edge as the start point.
❒The minimum available space between the start point and the end point is 30 mm.
❒If you do not set the end point after setting the start point (a), the copier will regard the trailing edge of the original as the end point (b).
❒If you do not set the end point in the Semi Synchro Cutting function, the pa- per extend by 200mm from the end point (from c to d). The paper extend by 310mm from the trailing edge.
A Hold down the {Function Select} key for three seconds or more.
A "P" will blink in the copy counter display.
32
