Manuals / Brands / Computer Equipment / Computer Hardware / SBE / Computer Equipment / Computer Hardware

SBE HW400c/2 3.4.1 Switch Re 3.4.2 MV64462 S s , 3.4.3 Front Panel (RJ-45) Ethernet Interface , gisters Initialization and Monitoring , y tem Controller Ethernet Interface

1 104

Download 104 pages, 1.68 Mb

HighWire HW400c/2 User Reference Guide Rev 1.0

3.4.1 Switch Re3.4.2 MV64462 S s

the HW400c/2 can be accessed via the

000 Mbps and is a

rced from the Ethernet switch. The

the receiver signals on the

stem controller, and vice-versa for a direct MAC-to-MAC connection.

3.4.3 Front Panel (RJ-45) Ethernet Interface

he HW400c/2 board lded RJ-45 (with integrated transformer

nd two s) located at the front panel that provides an Ethernet LAN

terface. The port is auto-negotiating and auto-sensing, and operates at 10/100/1000

bps. The left LED (looking at the port) indicates Link/Activity/Speed and the right

ED indicates collision detection (See Figure 12).

The Link

solid green when the network link is up;

Hz for 10 Mb/s Tx or Rx;

• blinking at 6 Hz for 100 Mb/s Tx or Rx;

gisters Initialization and Monitoring

The switch is initialized and its registers polled by utilizing its SPI bus interface.

This interface is connected through the CPLD. For a description of how to access the

SPI interface, please refer to Section 4.4.

y tem Controller Ethernet Interface

The Marvell MV64462 System Controller on

BCM5388 Ethernet switch. The connection speed must be set to 1

MAC-to-MAC connection with the clock sou

transmitter signals from the switch are connected to

sy

T includes a fully shie

a

in green LED

M

L

/Activity/Speed LED indication is as follows:

•

• blinking at 3

• and blinking at 12 Hz for 1000 Mb/s Tx or Rx.

Ethernet

Link/activit speed Collision y/

Figure 12. Front panel Ethernet RJ-45 LEDs

October 10, 2006 Copyright 2006, SBE, Inc. Page 28

Contents

Main HighWire HW400c/2 User Reference Guide Rev 1.0 October 10, 2006 Copyright 2006, SBE, Inc. Page ii Revision History Page Table of Contents 1 2 3 Page 4 5 Appendix A Appendix B List of Figures List of Tables Page Page Conventions ! 1 2 2.1 Product Description HighWire HW400c/2 User Reference Guide Rev 1.0 Figure 1. HW400c/2 Block Diagram October 10, 2006 Copyright 2006, SBE, Inc. Page 3 2.2 Unpacking Instructions 2.3 Handling Procedures 2.4 Hardware Installation of the HW400c/2 2.5 Returns/Service 2.6 Operating Environment ! Page 2.8 Regulatory Agency Certifications 2.8.1 Safety 2.8.2 US and Canadian Emissions 2.8.3 European Emissions and Immunity 2.9 Agency Compliance 2.10 Physical Properties 2.10.1 HW400c/2 Front Panel 2.10.2 Part number and serial number .10.3 Bus Keying 2 2.10.4 Power Requirements 2.10.5 Switches 2.10.6 Product Configurations 3 3.1 PowerPC Processor 3.1.1 MPC744X Development/Debug Support 3.1.2 Console port 3.1.3 Pushbutton Reset / Interrupt Page 3.1.4 COP/JTAG Port rpose Jumper Block 3.1.5 Special Pu 3.2 MV64462 Sy 3.2.1 System Bu 3.2.2 Dual Data stem Controller s 3.2.3 Host PCI B 3.2.4 Local PCI us Bus 3.2.5 Serial EEPROM ! Page Page 3.2.6 MV64462 Ethernet Interface 3.2.7 MV64462 Device Interface 3.2.8 Watchdog Timer 3.2.9 Reset 3.2.10 Multi-Purpose Port (MPP) Usage 3.3 Computer Telephony Bus Controller 3.3.1 H.110 Interface (T8110L) 3.3.2 T8110L Clocking Interface (T8110L) Page 3.3.3 Operation in Non-H.110 Backplane 3.4 Layer 2 Ethernet Switch 3.4.1 Switch Re 3.4.2 MV64462 S s 3.4.3 Front Panel (RJ-45) Ethernet Interface gisters Initialization and Monitoring y tem Controller Ethernet Interface 3ernet Ports .4.4 PT5MC Eth ! 3 ! 3.4.6 On-board Ethernet Indicator LEDs Page 3.5 Mezzanine Card Sites 3.5.1 PT5MC Type Mezzanine Cards 2MC Type M 3.5.2 PT ezzanine Cards 3.5.3 PMC Type 3.5.4 Mezzanine Card Power 3.5.5 C Conn r Summ y PTMC/PM ecto ar HighWire HW400c/2 User Reference Guide Rev 1.0 3.5.6 PTMC Jn1 and Jn2 PCI Connectors d IEEE P1386.1. Pn1 32-Bit PCI Pn2 32-Bit PCI Pin # Signal Name Signal Name Pin # Pin # Signal Name Signal Name Pin 3.5.7 PTMC Jn3 CT Bus Connector Pin # Signal Name Signal Name # # Signal Name Signal Name # Pin Pin Pin October 10, 2006 Copyright 2006, SBE, Inc. Page 35 .5.8 PTMC Jn4 LAN/User I/O Connector 3 HighWire HW400c/2 User Reference Guide Rev 1.0 Tabl Pn4 PT2MC Pn4 PT5MC e 20. PTMC Site A Configuration #2/#5 Pn4 Connector Pin Assignment October 10, 2006 Copyright 2006, SBE, Inc. Page 37 Pin # Signal Pin Pin Pin Name Signal Name # # Signal Name Signal Name # HighWire HW400c/2 User Reference Guide Rev 1.0 October 10, 2006 Copyright 2006, SBE, Inc. Page 38 ble 14. c ! 3.6 IPMI System Management 3.6.1 IPMI Controller 3.6.2 Temperatu re and Voltage Monitor 3.6.3 Hot Swap 3.6.4 Blue (Hot Swap) LED Control 3.6.5 Boot Status Monitor Ejector Latch Detection 3.6.6 Board Reset via IPMI 3.6.7 IPMI System Power Supply 3.6.8 IPMI Firmw are EEPROMs 3.6.9 Zircon PM 3.6.10 IMPI Get Reset Device ID 3.7 Hot Swap Support 3.7.1 Hot Swap o 3.7.2 Hot Swap on J3 3.7.3 Hot Swap on J4 3.7.4 Hot Swap on J5 3.7.5 Hot Swap Sequence 4 .1 HW400c/2 M 4 emory Map 4.2 CPLD Registers HighWire HW400c/2 User Reference Guide Rev 1.0 4.2.1 Clock Select Register (CSR) October 10, 2006 Copyright 2006, SBE, Inc. Page 48 4.2.2 Board Status Register (BSR) 4.2.3 LED Regis ter A (LEDA) 4.2.4 Memory Option Register (MOR) 4.2.5 Geographi c Addressing Register (GAR) 4.2.6 PTMC Reset Register (PRR) 4.2.7 PTMC Con trol Register (PCR) 4.2.8 Board Option Register (BOR) 4.2.9 General Purpose Register (GPR) 4.2.10 PCI Status Register (PSR) 4.2.11 Extended Type Register (ETR) 4.2.12 Hardware Revision Register (HRR) 4.2.13 PLL Conf uration Re r A ig giste (PLLA) 4.2.14 PLL Configuration Register B (PLLB) 4.2.15 LED Register B (LEDB) 4.2.16 Device Control Register (DCR) 4.2.17 CPU Timer Register (CTR) 4.2.18 Warm Reset Register (WRR) 4.2.19 SPI Page egister (SP R R) 4.2.20 SPI Addre ss Register (SAR) 4.2.21 SPI Read Byte Offset Register (SOR) 4.2.22 Read Byt e Count Register (RBC) 4.2.23 Write Byte Count Register (WBC) 4.2.24 SPI Data egisters (S S R DR0 DR7) 4.2.25 SPI Error and Status Register (SESR) 4.2.26 EEPROM ddress (EAR) A Register R) 4.2.27 EEPROM Operation/Status Register (EOS 4.2.28 EEPROM Data Registers (EDR0 EDR1) 4.3 Accessing the Serial EEPROM 4.3.1 Reading a n EEPROM Address 4.3.2 Writing an 4.4 Accessing t 4.4.1 Registers 4.4.2 BCM5388 EEPROM Address ! 5388 Register ! Page 5 W400C/2 AND HOST SYSTEM 5.1 Host Hardwa re and Software Requirements 5.2 Network and System Configuration 5.3 Installing Lin ux on your host system 5.4 Configuring 5.4.1 Modifying 5.4.2 Configurin the Host System the Host Path 5.4.3 Configurin g Host tftp services 5.4.4 Configuring tftp with inetd uImage Page d 5.4.5 Configuring tftp with xinet 5.4.6 Configuring a bootp Server .5 Booting the W400c/2 5 H 5.5.1 U-boot, Universal Bootloader Page Page Page 5.5.2 Booting with tftp Page HighWire HW400c/2 User Reference Guide Rev 1.0 October 10, 2006 Copyright 2006, SBE, Inc. Page 82 HighWire HW400c/2 User Reference Guide Rev 1.0 October 10, 2006 Copyright 2006, SBE, Inc. Page 83 5.5.3 Booting with Disk on Chip Page 5.6 Compiling the Kernel (uImage) 5.6.1 Gentoo Application Packages Management Page 5.7 Linux Device Drivers ! HighWire HW400c/2 User Reference Guide Rev 1.0 Appendix A October 10, 2006 Copyright 2006, SBE, Inc. Page 90 Byte offset Description IPMI Definition SBE value Comments IPMI GetDeviceID Appendix B