HighWire HW400c/2 User Reference Guide Rev 1.0
4.2.6 PTMC Reset Register (PRR)
PTMC Reset Register (PRR) is a Read/Write register that asserts and de-asserts reset
to the individual PTMC sites. The Reset pulse applied to the PTMC modules must
conform to the PCI
standard, that is, it must be at least 10 PCI clock cycles long.
Table 35. PTMC Reset Register (PRR) Offset Address 0x09
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Re d PMCRSTB PMCRSTA Re d Re d Re d Re d Re dserve serve serve serve serve serve
P = 0 De-a S T (de lt state)
= 1 Assert PMC Site B RESET
De- fault state)
Ass
4.2.7 PTMC Con
he PTMC Control Register (PCR) is a Read/Write register. The interoperability of
ach PTMC mezzanine card can be detected by reading this register. After reading
each card’s PTID bits, the processor can enable the card by setting the site’s PTEN
vention is required for PTIDx[2:0] = 010 or 101, which
are the codes for PT2MC and PT5MC, respectively. When either of these codes is
e
Control Register (PCR) Offset Address 0x0A
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
MCRSTB ssert PMC ite B RESE fau
PMCRSTA = 0 assert PMC Site A RESET (de
= 1 ert PMC Site A RESET
trol Register (PCR)
T
e
bit to “1”. No processor inter
detected by the CPLD, the PTEN bit for the site is set to “1” automatically, and th
card in that site is enabled.
Table 36. PTMC
PTENB PTIDA0 PTIDB2 PTIDB1 PTIDB0 PTENA PTIDA2 PTIDA1
R/W R R R R/W R R R
P
ite
TIDB[2:0] = 000 Site B is 32-bit PMC type, or is not present
ype, or PT7MC type
TENA
C Site A Enabled
TIDB[2:0] = 000 Site A is 32-bit PMC type, or is not present
= 010 Site A is PT2MC type
= 101 Site A is PT5MC type
= 111 Site A is 64-bit PMC type, or PT7MC type
TENB = 0 PTMC Site B Disabled
PTMC S= 1 B Enabled
P
= 010 Site B is PT2MC type
= 101 Site B is PT5MC type
= 111 Site B is 64-bit PMC t
P = 0 PTMC Site A Disabled
= 1 PTM
P
October 10, 2006 Copyright 2006, SBE, Inc. Page 51