Manuals / Schwinn / Personal Care / Mobility Scooter

Schwinn 250 schwinn manual Connect Heart Rate Cable to Seat Assembly, X2 G D

Models: 250 schwinn

1 52

Download 52 pages 24.76 Kb

Page 11

7. Connect Heart Rate Cable to Seat Assembly

7. Connect Heart Rate Cable to Seat Assembly

NOTICE: Do not crimp the Heart Rate Cable.

8. Attach Seat Rail Bracket to Seat Rail Assembly

NOTICE: Do not crimp the Heart Rate Cable. Hardware was pre-installed and not on

hardware card.

8

X2

G

D

11

Image 11

Schwinn 250 schwinn Connect Heart Rate Cable to Seat Assembly, Attach Seat Rail Bracket to Seat Rail Assembly, X2 G D

Contents

ASSEMBLY MANUAL / OWNER’S MANUAL Table of Contents Obey the following warnings Important Safety Instructions -AssemblyFCC Compliance Safety Warning Labels and Serial NumberBefore Assembly SpecificationsPARTS A B C D E F G H I J HARDWARE / TOOLsTools 2. Remove Seat Rail Bracket from Seat Rail ASSEMBLY1. Remove Seat Rail from Frame and Disconnect Heart Rate Cable X4 G D 3. Attach Stabilizers to Frame4. Attach Side Handlebar to Seat Frame X4 FX8 G L 5. Attach Seat Pads to Seat Frame AssemblyX2 G D 7. Connect Heart Rate Cable to Seat Assembly8. Attach Seat Rail Bracket to Seat Rail Assembly X7 G D 9. Attach Seat Rail Assembly to Frame Assembly10. Attach Console Mast to Frame Assembly X2 16N M I H 11. Attach Upright Handlebar to Console MastNOTICE Do not crimp the cables 12. Attach Console Bracket to Console MastNOTICE Do not crimp the cables Note Hardware is pre-installed 13. Remove Hardware from Console14. Connect Cables and Attach Console to Frame Assembly NOTICE Tighten hardware and install Caps 15. Adjust and Tighten the Console Mast and Console16. Attach Pedals to Frame Assembly 18. Final Inspection 17. Connect AC Adapter to Frame AssemblyMoving the Bike BEFORE YOU STARTLeveling the Bike Before using this equipment, obey the following warnings Important Safety InstructionsFEATURES Keypad Functions Console FeaturesSpeed / RPM LCD Display DataProgram Display Time / IntervalPulse Heart Rate Remote Heart Rate MonitorContact Heart Rate Sensors Heart Rate Calculations FAT-BURNING TARGET HEART RATE What to Wear OperationsConsole Adjustment Power-Up / Idle ModeAuto Shut-Off Sleep Mode Initial SetupGuest User / Profile Program Quick Start / Manual ProgramAdd User Profile Schwinn Advantage User Setup ModeUser Profile Workout Program Edit User Profile Custom Workout Delete a User ProfileCourse Profile ProgramsChanging Resistance Levels CourseHeart Rate Control HRC Workout Fitness TestDistance Goal Program Results / Cool Down ModeUser Statistics Pausing or StoppingPage CONSOLE SETUP MODE Page bolts and screws are tight. Tighten as necessary MAINTENANCEMonthly or after 20 hoursMaintenance Parts Console Things to Check TroubleshootingCondition/Problem Solutionconnector should line up and snap into If tests reveal no other issues, HandleConsole displays “E2” error All wires in cable should be intact. If anyThings to Check Condition/ProblemSolution Be sure adjustment pin is locked into Check leveler adjustmentAdjust levelers until bike is level Adjustment may not be able to comPage Who Is Covered LIMITED WARRANTYWhat Is Covered What Is Not CoveredUniversal NautilusBowflex Schwinn Fitness