Manuals / Schwinn / Personal Care / Mobility Scooter

Schwinn 250 schwinn manual Assembly, Remove Seat Rail from Frame and Disconnect Heart Rate Cable

Models: 250 schwinn

1 52

Download 52 pages 24.76 Kb

Page 8

ASSEMBLY

ASSEMBLY

1. Remove Seat Rail from Frame and Disconnect Heart Rate Cable

NOTICE: Make sure that the heart rate cable does not fall into the frame tube. Hardware is not on hardware card.

4		X7
		X7
	11	D
	11
		G

2. Remove Seat Rail Bracket from Seat Rail

NOTICE: Hardware is not on hardware card.

X2

G

D

8

8

Image 8

Schwinn 250 schwinn manual Assembly, Remove Seat Rail from Frame and Disconnect Heart Rate Cable

Contents

ASSEMBLY MANUAL / OWNER’S MANUAL Table of Contents Important Safety Instructions -Assembly Obey the following warningsSafety Warning Labels and Serial Number FCC ComplianceSpecifications Before AssemblyPARTS A B C D E F G H I J HARDWARE / TOOLsTools 2. Remove Seat Rail Bracket from Seat Rail ASSEMBLY1. Remove Seat Rail from Frame and Disconnect Heart Rate Cable 3. Attach Stabilizers to Frame 4. Attach Side Handlebar to Seat FrameX4 F X4 G D5. Attach Seat Pads to Seat Frame Assembly X8 G LX2 G D 7. Connect Heart Rate Cable to Seat Assembly8. Attach Seat Rail Bracket to Seat Rail Assembly 9. Attach Seat Rail Assembly to Frame Assembly X7 G D10. Attach Console Mast to Frame Assembly 11. Attach Upright Handlebar to Console Mast X2 16N M I H12. Attach Console Bracket to Console Mast NOTICE Do not crimp the cables13. Remove Hardware from Console NOTICE Do not crimp the cables Note Hardware is pre-installed14. Connect Cables and Attach Console to Frame Assembly 15. Adjust and Tighten the Console Mast and Console NOTICE Tighten hardware and install Caps16. Attach Pedals to Frame Assembly 17. Connect AC Adapter to Frame Assembly 18. Final InspectionMoving the Bike BEFORE YOU STARTLeveling the Bike Important Safety Instructions Before using this equipment, obey the following warningsFEATURES Console Features Keypad FunctionsLCD Display Data Program DisplayTime / Interval Speed / RPMPulse Heart Rate Remote Heart Rate MonitorContact Heart Rate Sensors Heart Rate Calculations FAT-BURNING TARGET HEART RATE Operations What to WearPower-Up / Idle Mode Initial SetupAuto Shut-Off Sleep Mode Console AdjustmentQuick Start / Manual Program Guest User / Profile ProgramSchwinn Advantage User Setup Mode Add User ProfileUser Profile Workout Program Edit User Profile Delete a User Profile Custom WorkoutProfile Programs Changing Resistance LevelsCourse CourseFitness Test Heart Rate Control HRC WorkoutDistance Goal Program Results / Cool Down ModePausing or Stopping User StatisticsPage CONSOLE SETUP MODE Page MAINTENANCE Monthlyor after 20 hours bolts and screws are tight. Tighten as necessaryMaintenance Parts Console Troubleshooting Condition/ProblemSolution Things to CheckIf tests reveal no other issues, Handle Console displays “E2” errorAll wires in cable should be intact. If any connector should line up and snap intoThings to Check Condition/ProblemSolution Check leveler adjustment Adjust levelers until bike is levelAdjustment may not be able to com Be sure adjustment pin is locked intoPage LIMITED WARRANTY What Is CoveredWhat Is Not Covered Who Is CoveredNautilus BowflexSchwinn Fitness Universal