MDT5N25 & MDT5N40
REMOVAL AND REPLACEMENT: Water Seal
To Remove the Water Seal:
(Assuming all steps to remove the auger have been performed.)
1.The gearmotor/evaporator assembly will have to be exposed. (See illustration - next page)
2.Remove the 4 hex head cap screws holding the evaporator to the gearmotor assembly. Lift the evaporator up and off of the gearmotor.
3.Remove the snap ring or wire retainer from the grove under the water seal.
4.Pull or drive out the lower half of the water seal.
To Replace the Water Seal:
1.Lubricate the water seal with water, and push the water seal into the bottom of the evaporator slightly past the grove for the snap ring.
5.Carefully push the water seal (rubber side against the auger shoulder and the silastic.)
CAUTION
Do not get any silastic onto the face of the seal.
6.Allow the auger and seal to air dry until the silastic is dry on the surface.
WATER
SEAL
RETAINING
RING
2.Replace the snap ring and pull the water seal down against it.
3.The part of the water seal that rotates with the auger must also be replaced. Remove the old part from the auger and clean the mounting area.
4.Place a small bead of food grade silastic sealant (such as 732 RTV or Scotsman part number
FOOD GRADE
SILASTIC
SEALANT
HERE
7.If the original water seal was leaking, it would be a good idea to inspect the interior of the gearmotor.