9. Holdrodwithonehandandwitha1/2in. wrench or
pliers start screwing on ONE of the nuts only A TURN OR TWO .... screw on other nut the same way
10_ Using TWO 1/2 in,, wrenches or pliers tighten both of the nuts,
IMPORTANT: | Apply | a coat | of | paste | wax to the top surface | |||||
and front | edge of | the | front | guide | bar, | This will | allow | the | ||
fence to | slide | more | easily, |
|
|
|
|
|
| |
11o Slide | the | bars | so that screws | are | in | the MIDDLE | of | the | ||
slotted | ho_eso |
|
|
|
|
|
|
|
| |
12.Position rip fence over miter gauge groove, holding up the rear end while engaging front end with bar o.. lower fence onto table°
!3,, Raise blade all the way up.
14. Carefully move fence against blade.
15, Move front bar until "0" mark on rip scale is
approximately in line with indicator°
16.Move FRONT bar upwards until fence is approximately 1/32 in,, above table .... tighten screw at left end of bar_,
NOTE: Fold a piece of newspaper making 8 thicknesses and place between rip fence and table to act as a spacer. This will hold the fence off of the table approx. 1/32 in,
17,, Adjust rear bar so that the fence is approximately 1/32 in, above table make sure it is square with fence guide bar rod .. , tighten screw at end of bar.
18,, Replace screws in rear of table extension .... be sure
top surface of extension is PARALLEL to top surface of rear guide bar,,
19_ Move fence to RIGHT edge of table .... make sure it is
approxo 1/32 in. above table at front and rear and tighten screws.
8THICKNESSES OF PAPER
8THICKNESSES OF PAPER
Io
