GETTING TO KNOW YOUR SAW
6 RiP FENCE 11
7 MITER GAUGE
8 BLADE GUARD
10!
TILT LOCK KNOB
9 TABLE INSERT
ELEVATION LOCK HANDLE
TILT CRANK
1
CAUTION: Before turning switch on, make sure the blade guard is correctly installed and operating properly.
The
lS iNTENDED TO PREVENT UNAUTHORIZED AND
POSSIBLE HAZARDOUS USE BY CHILDREN AND OTHERS.
BTO turn saw ON ..... stand to either side of the
blade never in line with it , insert finger under switch lever and pull END of lever out
After turning switch ON, always allow the blade to come up to fult speed before cutting,
Do not cycle the motor switch on and off rapidly, as this may cause the sawblade to loosen, tn the event this should ever occur, allow the sawblade to
| come to | a complete | stop | and | retighten | the | arbor | |||||
| nut normally_ not excessively, Never leave the saw | |||||||||||
| while | the | power | is "'ON" |
|
|
|
|
|
|
| |
C, | TO | turn | saw OFF | .... | PUSH | lever | in,, | Never | leave | |||
| the | saw | unti{ | the | cutting | tool | has | come | to | a | ||
| complete | stop, |
|
|
|
|
|
|
|
|
| |
D, | TO | lock | switch | in OFF | position | , | hold switch | IN | ||||
| with | one | hand | , _ . | REMOVE | key with | other | hand | ||||
2
ELEVATION HANDWHEEL
© | O O |
\
KEY
©
WARNING: FOR YOUR OWN SAFETY, LOWER
BLADE OR OTHER CUTTING TOOL BELOW
TABLE SURFACE, (IF BLADE IS TILTED,
RETURN IT TO VERTICAL (90 °) POSITION).
ALWAYS LOCK THE SWITCH "OFF". WHEN
SAW IS NOT IN USE ..o REMOVE KEY AND
KEEP tT IN A SAFE PLACE ... ALSO ..o IN
THE EVENT OF A POWER FAILURE (ALL OF
YOUR LIGHTS GO OUT) TURN SWITCH OFF
.._ LOCK IT AND REMOVE THE KEY. THIS
WILL PREVENT THE SAW FROM STARTING UP
AGAIN WHEN THE POWER COMES BACK ON.
14
