If the fence does not slide easily along the bars, the pressure of the spring can be REDUCED,
_. Loosen the screws,_
2., Move spring slightly toward rear of fence .... tighten
screws.
\\
HEX SCREWS
The rip fence must be PARALLEL with the sawbtade
(see page 23) and Miter Gauge grooves .... Move fence
F[ NCE_HEAD_
until it is along side of groove. Do NOT LOCK IT tt shouM be parallel to groove. If it is not;
A,, Loosen the two "Hex,, Head Screws,'"
13.Hold fence head tightly against bar ,, . move end of fence so that it is parallel with groove.
Co Alternately tighter{ the screws_
ADJUSTING |
| RIP | SCALE | INDICATOR |
|
|
|
|
| |||||
| Turn | ELEVATION | handwheel | clockwise | until | blade | is | |||||||
| up as high as it w{If go., |
|
|
|
|
|
|
|
| |||||
| IMPORTANT: | BLADE | must | be | SQUARE | (90 ° ) | to | |||||||
| TABLE, in order to ALIGN rip fence. |
|
|
|
| |||||||||
Z | Position |
| fence | on | right | side | of | sawblade so | that | it | ||||
| touches the sides of the teeth .... tighten lock knob. |
| ||||||||||||
3, | Loosen | screw | holding | the | indicator | _ ,, | adjust | indicator | ||||||
| so | that | it | points | to | "0". | o • tighten | screw° |
|
|
| |||
| NOTE: | If | you | cannot | ad'lust | indicator | so that | it | points | |||||
| to | "0", | loosen | the | screws | hofding | the | front | guide | bar | ||||
| and move the guide bar, |
|
|
|
|
|
|
| ||||||
INSTALLING BLADE GUARD
1, From amoung the loose parts, find the hardware,.
2, Attach SPREADER to SPREADER SUPPORT so that screws are all the way back in the SLOTS of SUPPORT
.... hand tighten screws,
LOCK HANDLE "_
THUMB SCREW
SUPPORT
SPREADER ROD
12
