ASSEMBLY STEP 4

Install the Chain/Cable

and Attach the Sprocket Cover

1.Pull the cable around the idler pulley and toward
the trolley.
2. Connect the cable loop tothe retaining slot onthe
trolley, as shown:
• From below, push pins of master link bar up
through cable loop and trolley slot.
• Push master link cap over pins and past pin
notches.
• Slide clip-on spring over cap and onto pin
notches until both pins are securely locked in
place.
3. With the trolley against the pliers, dispense the
remainder of the cable/chain along the rail toward
the motor unit and around the sprocket. The
sprocket teeth must engage the chain.
4. Check to make sure the chain is nottwisted, then
connect itto the threaded shaft with the
remaining master link.
5. Thread the inner nut and lock washer onto the the
trolley shaft.
6. Insert the trolley threaded shaft through the hole
in the trolley. Be sure thechain is not twisted.
7. Loosely thread the outer nut onto the trolley shaft.
8. Remove the locking pliers.
9. Align the tabs on the sprocket cover with the slots
in the mounting plate. Squeeze cover and insert
tabs in slots.
Toavoid possible SERIOUSINJURY to fingers from
moving garage door opener:
• ALWAYSkeephand clear of sprocket while operating
opener.
• Securelyattach sprocket cover BEFOREoperating.
Dispensing Carton
Leave Chain and Cable
Inside Dispensing
Carton to Prevent Kinking.
Keep Chain and Cable
Taut When Dispensing
Master Link._ Master
Chp-On Spnng _ Ltnk Cap
I i
Master Link _ Master
Clip-OnSpringCable_ _r'-___jl1 Link Cap ' i
Trolley : , Pin
edThreaded , I Noch
Shaft i :
i Master r
Round Link Bar
Idler
Pulley I ' Slotted
, i Hole
: : Cover
Cable ........ _"
(_ Unk Bar Front ' '
Tab SIot :
Motor Unit
Sprocket
Back
Tab Slot
Mounting
10