Sears 139.53975SRT1 Using WaU.Mounted Door Control, To Open the Door Manually, Light Feature

Using		the	WaU.Mounted
Door		Control
THE PREMIUM			CONTROL CONSOLE
Light	feature			LIGHTED
Press	the Light		button to turn	PUSH BUTTON
				I-f_
the opener light on or off. It will
not control the			opener lights	LIGHT
when the door is in motion. If
you turn		it on and then activate		LOCK
				B_iTTON
the opener, the light will remain				TTON
on for 4-1/2 minutes. Press
again	to turn it off sooner.
Lock	feature

Designed to prevent operation of the door from hand- held remote controls. However, the door will open and close from the Door Control, the Outdoor Key Switch and the Keyless Entry Accessories.

To activate, press and hold the Lock button for 2

seconds. The push button light will flash as long as the Lock feature is on.

To turn off, press and hold the Lock button again for 2 seconds. The push button light will stop flashing. The Lock feature will also turn off whenever the SRT

(Smart Receiver/Transmitter) button on the motor unit panel is activated.

Additional feature when used with the 3-function hand-held remote

To control the opener lights:

In addition to operating the door, you /._ may program the remote to operate

the lights.

1.With the door closed, press and

hold a small remote button that you want to control the light.

2.Press and hold the Light button on the Premium Control Console.

3.While holding the Light button, press and hold the Lock button on the door control.

4.After the opener lights flash, release all buttons.

To Open the Door Manually

•To prevent possible SERIOUSINJURYor DEATHfrom a falling garagedoor:

-If possible, use emergency release handleto

disengagetrolley ONLYwhen garage door is CLOSED.Weakor broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly.

-NEVERuse emergency releasehandle unless garage doorway is clear of persons and obstructions.

•NEVERuse handleto pull door open or closed. If rope knot becomes untied, you could fall.

DISCONNECTTHETROLLEY:
The door should be fully closed					Trolley
if possible. Pull down on the					_	I
emergency		release		handle (so
that the trolley release arm
snaps into a vertical position)					Trolley	..j
and lift the door manually. The
					Release am
lockout	feature		prevents the		(In Manual
					Disconnect
trolley	from	reconnecting
					Posilion)
automatically, and the door can
be raised and lowered manually
as often as necessary.					Lockout	position
					(Manual	disconnect)
TO RE-CONNECT THE TROLLEY:
Pull the emergency				release	Troltey
a 45° degree angle so that
the trolley release arm is
horizontal. The			trolley will		_I_IY	Trolley
handle	toward		the opener at			Release
reconnect on the next UP or
DOWN	operation,			either	Emergency	"__
manually or		by using the			(Pullat45OanglRelease Handlee)- ,/_.._," #
door control		or	remote.

To reconnect

32