Sears 139.53962SRT1, 139.53975SRT1 INSTALLATION STEP 7 Install the Lights and Lenses, INSTALLATION STEP 8 Attach the Emergency Release Rope and Handle

INSTALLATION STEP 7
Install the Lights and Lenses
•Install a 75 watt maximum light bulb in each
socket. The lights will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the lights will turn OFF.
• Apply slight pressure on the sides of each lens
and slide the tabs into the slots in the side panels.
(See illustration.)
• For convenience, the lenses may be installed
after Adjustment Step 4 on page 30.
• Toremove, reverse the procedure. Use care to
avoid snapping off lens tabs.
• Use standard neck Garage Door Opener bulbs for
replacement.
/
Lens
Tab
75Watl Max.
LenSrab/_ Lighl Bulb
Lensf
Tab
Lens
Guide
Lens
Siot
/
INSTALLATION STEP 8
Attach the Emergency Release
Rope and Handle
• Thread one end of the ropethrough the hole inthe
top of the red handle so "NOTICE" reads right side
up as shown. Secure with an overhand knot at
least 1"from theend of the rope to prevent
slipping.
• Thread the other end of the ropethrough the hole
in the release arm ofthe outer trolley.
• Adjust rope length so the handle is 6 feet above
the floor. Secure with an overhand knot.
NOTE: If it is necessary to cut the rope, heat seal
the cut end with a match or lighter toprevent
unraveling.
• Toprevent possible SERIOUSINJURYor DEATHfrom
afalling garagedoor:
-If possible, useemergency releasehandle to
disengagetrolley ONLYwhen garage door is
OLOSED.Weakor brokensprings or unbalanced
door could result in an opendoor falling rapidly
and/or unexpectedly.
-NEVERuseemergency releasehandle unless garage
doorway is clear of personsand obstructions.
• NEVERusehandle to pull door open or closed.If rope
knot becomesuntied, you could fall.
Trolley
Emergency _, _) KCVe[hand
Release Handle i_
19