Putting the receiver into operation
N O P Q R S
Connecting and positioning remote antennas
Use remote antennas when the position of the double receiver is not the best antenna position for optimum reception. Remote antennas are available as accessories.
Connect the remote antennas to the BNC sockets Oand Rusing a low- attenuation
If you connect active antennas (e.g. A 3700, AD 3700) or antenna boosters (e.g. AB 3700), switch on the DC supply voltage for external
active antennas and antenna boosters (see page 32) so that the LEDs N and/or S light up;
if you do not connect active antennas or antenna boosters, switch off the booster supply voltage so that the LEDs N and/or S do not light up.
If the booster supply voltage is switched on (see page 32), it remains switched on even when the receiver is switched off.
Position antennas in the same room in which the transmission takes place! Maintain a minimum distance of 1 m between antennas and a minimum distance of 50 cm between antennas and metal objects (including reinforced concrete walls).
ANT A |
| ANT B | The receivers feature an integrated antenna splitter so that up to eight |
| receivers can be daisy chained using the supplied short antenna daisy | ||
|
|
| |
|
|
| chain cables. The type plate U indicates the daisy chained frequency |
|
|
| range. |
|
|
| Connect the two supplied antennas or two remote antennas (available |
|
|
| as accessories) to the BNC sockets O and R at the rear of the first |
|
|
| receiver. |
|
|
| Use the supplied |
|
|
| receivers as shown in the diagram on the left. |
| V |
| The antenna signals are also daisy chained when a receiver is |
|
| switched off. If the booster supply voltage is switched on (see | |
|
|
| |
|
|
| page 32), it remains switched on even when the receiver is |
|
|
| switched off. |
16