Sennheiser EM 3731-II, EM 3732-II Identified

Using the receiver

Position the transmitter’s infra-red interface at a max. distance of 5 cm in front of the infra-red interface (sync) A.

			The transfer starts automatically. During the transfer, the two blue
save digital audio	A RF B		LEDs in the infra-red interface (sync) A flash and the backlighting of
save digital audio			the sync button 9 flashes green.
processing
processing	300	PEA
sync	100	1
sync	30
esc	30		– After successful completion of the synchronization, the two blue
esc	μV
sync	μV
	10
			LEDs in the infra-red interface (sync) A stop flashing and the
			sync button 9is backlit in green. The receiver’s frequency and name
			are now also set on the transmitter and the transmission link is ready
< 5cm			for operation.
< 5cm			– If an error occurred during synchronization (e.g. the transmitter is

			too far away from the receiver), the two blue LEDs in the infra-red
			interface (sync) A stop flashing and the sync button 9 is backlit in
			red.
			The infra-red interface of the SKM 5200-II hand-held transmitter is
			located at the left-hand margin of the display. Position the
			transmitter’s infra-red interface precisely in front of the receiver’s
			infra-red interface (sync) A.
SKM 5200-II

6.000 Hz

save clock

Identifying receivers using the “Wireless Systems Manager” software (identifying function)

In multi-channel operation, it can be useful to identify the individual channels of the receivers via the “Wireless Systems Manager” software. The identifying function shows you which channel is assigned to which receiver.

Start the identifying function as described in the instruction manual of the “Wireless Systems Manger” software.

“Identified” appears on the status display of the identified receiver:

Identified

After 60 seconds, the text disappears and the current status display is shown again.

To change to the current status display before the end of the 60 seconds:

Press the esc button 6.

.01BANK AF COM esc

sync