Sennheiser EM 3731-II, EM 3732-II Using the receiver, Switching the receiver on/off, Connecting the headphones/adjusting the volume

Using the receiver

Using the receiver

Switching the receiver on/off

M		save clock
6.000 Hz		sync
.01CH	COM
BANK AF		esc

The EM 3731-II single receiver is switched on and off with the button C. The two receivers of the EM 3732-II or EM 3732-II COM twin

receiver are switched on and off together with the		button C. The
	button C is not a mains switch.

If you only want to use one of the two receivers of the EM 3732-II or EM 3732-II COM, you can set the second receiver to standby mode (see “Setting a receiver to standby mode” on page 40).

To switch the receiver on:

￿Press the button C.

The display shows the product name (e.g. EM 3731-II) and the serial number of the current firmware (behind “Software”). The status display appears after several seconds.

To switch the receiver off:

￿Press the button C for approx 2 seconds until the display goes off. The receiver is switched off but daisy chained signals continue to be output. This means that:

–the daisy chain outputs Q and P output the antenna signals.

–if the booster supply voltage is switched on (see page 32), it remains switched on even when the receiver is switched off,

–the signal of the external word clock generator is looped through to the word clock daisy chain output I.

Connecting the headphones/adjusting the volume

CAUTION! Danger of hearing damage!

Listening at high volume levels for long periods can lead to permanent hearing defects.

￿ Set the volume for the connected headphones to the minimum before putting the headphones on.

The EM 3731-II single receiver features a headphone socket 2. The two receivers of the EM 3732-II or EM 3732-II COM twin receiver have a common headphone socket 2. This common headphone socket 2 allows you to either monitor the audio signal of one receiver or to simultaneously monitor the audio signals of both receivers.

￿Set the headphone volume control 3 to the lowest volume by turning

True Diversity Receiver EM 3732	300	PEAK	776.000	it to the left as far as possible.
	A RF B	% DEV
	100	100
	30	50	BAN
	10		01.01CH	￿ Connect headphones with a ¼” (6.3 mm) stereo jack plug to the
	∝V	10

headphone socket 2.

2 3

20