Sennheiser EM 3731-II, EM 3732-II 41

Adjustment tips for the operating menu

	0 1B		000
	6 00	OFF	000
	0 01	OFF	Rese
	AC	Standby	Rese
			OFF
DEV	M	save	digital audio
	800.450 Hz	sync	processing
	03.03CH	sync
	03.03CH	esc
	BANK AF COM	esc

Setting a receiver to standby mode

You can set a receiver to standby mode and mute it. To do so, proceed as follows:

Change to the setting mode of the “Standby” menu.

The icon and the green backlighting of the save button 8 flash.

Press the save button 8.

The esc button 6 is backlit in red. The receiver is set to standby mode

and the display is switched off.

OFF

sync

000

The standby mode remains active even when you switch the receiver off and on again.

To end the standby mode:

Press the jog dial 7 or the esc button 6. The display is switched on.

Loading the factory-preset default settings

Via the “Reset” menu, you can reset the current settings to the factory- preset default settings.

ndby Reset

Reset to

factory defaults ? 000

DEV	M	save digital audio
	776.000 Hz	processing
	01.01CH	sync
	01.01CH	esc
	BANK AF COM	esc

sync

Change to the setting mode of the “Reset” menu.

The query “Reset to factory defaults?” appears. The green backlighting of the save button 8 flashes.

Press the save button 8 until the progress bar is complete.

All settings except for the booster supply voltage, the sampling rate at the digital output and the network address are reset to the factory- preset default settings. The display changes to the selection mode of the operating menu.

40

Contents

Instruction manual Contents Important safety instructions Page Page The product family The frequency bank system Delivery includes Product overview Overview of the displays 776.000 Hz 01.01CH Reception display Mute NAME AF COM COM Putting the receiver into operation Slide the receiver into the 19" rack Secure the rack mount “ears” Connecting the antennas CAUTION! Danger of short-circuitdue to uninsulated antennas even when you switch the receiver off Page Daisy chaining receivers Connecting the receiver to the mains/ disconnecting the receiver from the mains CAUTION! Damage to the device due to electric current Ensure a reliable mains ground connection of the receiver – especially when you are using multi-outletpower strips or extension cables Plug the mains connector into the wall socket Connecting devices with AES3 digital input Connecting an external word clock generator Scanning Using the receiver Deactivating the lock mode Synchronizing a transmitter with the receiver frequency Identified Sorting channels using the “Wireless Systems Manager” software Using the operating menu 776.000 Hz Working with the operating menu esc 777.005MHz 848.225MHz Setting mode +12 dB +18 dB save NAME B.CH press and hold Adjustment tips for the operating menu CEL .16 CEL Repeat the last two steps to enter the remaining characters After you have entered the six characters of the name, press the save button Adjusting the squelch threshold To adjust the squelch threshold: After you have adjusted the desired squelch threshold, press the save button Page Page Page Page Before starting the scan, switch all transmitters of your system Turn the jog dial 7 until the arrow points to “Scan new” Press the jog dial 7 to start the scan Releasing channels that are used or subject to interference Turn the jog dial 7 until the arrow points to “Scan reset” NAME 01.01CH 03.03CH NAME Auto Page Cleaning the receiver Additional information Diversity reception If a problem occurs Accessories Specifications Page Manufacturer Declarations