A RF B

% DEV

M

save

100

100

776.000 z

 

300

PEAK

H

 

 

 

BANK

sync

30

 

AF COM esc

10

50

01.01CH

V

10

 

 

6 0

Using the receiver

To monitor the audio signal of one of the two receivers of a twin receiver:

￿Press the headphone button 0of the receiver whose audio signal you want to monitor.

To simultaneously monitor the audio signals of both receivers of a twin receiver:

￿Simultaneously press the headphone buttons 0of both receivers. The audio signal of the left receiver is output via the left headphone channel, the audio signal of the right receiver is output via the right headphone channel.

￿Gradually increase the volume.

To switch the headphone output off:

￿Press the headphone button 0 of the receiver whose headphone output you want to switch off.

Deactivating the lock mode

When the receivers are remote controlled via a PC and the “Wireless Systems Manager” software, their buttons can be locked via the “Wireless Systems Manager” software. To deactivate the lock mode:

 

￿ Press the esc button 6 until the progress bar is complete and the

Hold esc to unlock

status display appears.

The lock mode is deactivated and the settings can be made manually.

EV

M

save digital audio

 

776.000 Hz

processing

 

01.01CH

sync

 

esc

 

BANK AF COM

sync

9 A

Synchronizing a transmitter with the receiver frequency

Via its infra-red interface, the receiver can transfer the frequency and the name to suitable transmitters (e.g. SK 5212-II, SKM 5200-II, SK 5212, SKM 5200 or SKP 3000).

The transmitter must be from a compatible frequency range and be equipped with the same compander system (HDP, see page 42) as the receiver.

￿Set the receiver to the desired receiving frequency (see “Setting the receiving frequency” on page 30, “Selecting a frequency bank and a channel” on page 30) and enter the desired name (see “Entering a name” on page 31).

￿Press the sync button 9.

The two blue LEDs in the infra-red interface (sync) A flash and the backlighting of the sync button 9 flashes red. The receiver is ready for synchronization.

The sync button 9 can also be used for the sorting function of the “Wireless Systems Manager” software. For more information, refer to page 23.

21