Sennheiser EM 3731-II, EM 3732-II 34

		Booster Feed On
		7 8
DEV	M	save digital audio
	777.005 Hz	processing
	U.01 CH	sync
	U.01 CH	AF COM esc
	BANK	AF COM esc

sync

+12	48

oster AF Out

Cloc

+12 dB

+12

Adjustment tips for the operating menu

Change to the setting mode of the “Booster” menu. The current setting starts flashing.

Turn the jog dial 7 to change the setting to “Booster Feed On” or “Booster Feed Off”.

Press the save button 8.

The selected setting is stored. When the booster supply voltage is switched on, the two LEDs N and S light up. The display changes to the selection mode of the operating menu.

Adjusting the audio output level

Via the “AF Out” menu, you can adjust the maximum output level of the audio outputs (AF Out and Command).

With the EM 3732-II COM twin receiver, the audio level of the Command output 1 L corresponds to the level of the audio output 1 M and the audio level of the Command output 2 J corresponds to the level of the audio output 2 K.

The following figures are a guide to the best settings:

•Line level: +5 to +18 dB

•Microphone level: –10 to +4 dB

To obtain the best signal-to-noise ration, adjust the respective maximum audio level to the settings shown above.

Change to the setting mode of the “AF Out” menu. The current setting starts flashing.

		7 8
DEV	M	save digital audio
	777.005 Hz	processing
	U.01 CH	sync
	BANK AF COM	esc

sync

Turn the jog dial 7 to adjust the audio output level. The display shows the selected audio output level.

Press the save button 8.

The selected setting is stored. The display changes to the selection mode of the operating menu.

33

Contents

Instruction manual Contents Important safety instructions Page Page The product family The frequency bank system Delivery includes Product overview Overview of the displays 776.000 Hz 01.01CH Reception display Mute NAME AF COM COM Putting the receiver into operation Slide the receiver into the 19" rack Secure the rack mount “ears” Connecting the antennas CAUTION! Danger of short-circuitdue to uninsulated antennas even when you switch the receiver off Page Daisy chaining receivers Connecting the receiver to the mains/ disconnecting the receiver from the mains CAUTION! Damage to the device due to electric current Ensure a reliable mains ground connection of the receiver – especially when you are using multi-outletpower strips or extension cables Plug the mains connector into the wall socket Connecting devices with AES3 digital input Connecting an external word clock generator Scanning Using the receiver Deactivating the lock mode Synchronizing a transmitter with the receiver frequency Identified Sorting channels using the “Wireless Systems Manager” software Using the operating menu 776.000 Hz Working with the operating menu esc 777.005MHz 848.225MHz Setting mode +12 dB +18 dB save NAME B.CH press and hold Adjustment tips for the operating menu CEL .16 CEL Repeat the last two steps to enter the remaining characters After you have entered the six characters of the name, press the save button Adjusting the squelch threshold To adjust the squelch threshold: After you have adjusted the desired squelch threshold, press the save button Page Page Page Page Before starting the scan, switch all transmitters of your system Turn the jog dial 7 until the arrow points to “Scan new” Press the jog dial 7 to start the scan Releasing channels that are used or subject to interference Turn the jog dial 7 until the arrow points to “Scan reset” NAME 01.01CH 03.03CH NAME Auto Page Cleaning the receiver Additional information Diversity reception If a problem occurs Accessories Specifications Page Manufacturer Declarations