Servis-Rhino DM95, DM82, DM124, DM112 Lubrication Chart, Proper Torque For Fasteners, Maintenance

MAINTENANCE

Lubrication Chart

Location	Description	Lubrication Frequency
1	Front IID U-joint	After Every 8 Hours of Operation
2	Rear IID U-joint	After Every 8 Hours of Operation
3	IID Shaft Slip Joints	After Every 8 Hours of Operation
4	Gearboxes and Cutter Bar, Fill to respective Level	Check Level After Every 8 Hours
	Plug w/SAE EP90 or Equivalent Gear Lube	of Operation
5	Main Frame Pivot Point	Daily
6	All Sliding Sections	After Every 8 Hours of Operation
7	All Pivots & Linkage	After Every 8 Hours of Operation

PROPER TORQUE FOR FASTENERS

Because of the severe operating conditions, correct bolt torque is very important. An improperly torqued bolt can be easily shaken loose or broken by the vibrations. When replacing bolts, always use the same grade of bolt as used originally. Use this chart as a guide to tightening all bolts. Torque values listed are for general use only.

NOTE: These values apply to fasteners as received from supplier, dry or when lubricated with normal engine oil. They do not apply if special graphited or molydisulphide greases or other extreme pressure lubricants are used. This applies to both UNF fine and UNC coarse threads.

RECOMMENDED TORQUE IN FOOT POUNDS UNLESS OTHERWISE STATED IN THE MANUAL *

FIGURE 18

*

DM 07-02 Maintenance Section 5-6

© 2004 Alamo Group Inc.