ASSEMBLY
CAUTION! WEAR PROPER PROTECTIVE EQUIPMENT SUCH AS SAFETY GLASSES AND PROTECTIVE SHOES WHEN ASSEMBLING THE MOWER. USE OVERHEAD CRANE OR HOIST.
See pages 6-1 through 6-22 in the Parts List Section and identify the components to be installed. When the instructions refer to the left or right side, they refer to your left or right side, as you are standing behind the mower and facing the tractor. Refer to Torque Chart on Page 5-6 for correct torque on all bolts.
The Rhino Disc Mower is shipped partially assembled. Refer to the parts | |
lists for the location of the parts. | Figure 1 |
1. Unpack the main frame and fold the frame away from the cutter bar. (See Figure 1.)
CAUTION! BLOCKS SHOULD BE PLACED UNDER THE MAIN FRAME AND CUTTER BAR DURING ASSEMBLY TO ADD STABILITY AND REDUCE THE CHANCE OF PERSONAL INJURY.
2.Attach the 3-point frame to the main frame as shown in illustration 2 using the mainframe pin and two roll pins(B). Make sure the parts are clean and well lubricated.
3.Install the Stand Tube (A) in the 3-point frame and secure with the lock pin(C). (See Figure 2.)
4.Attach the suspension spring and suspension tube
assembly to the main frame and 3-point frame using a Short Suspension Tube Pin (B) at the main frame and a Suspension Rod Pin (C) at the 3-point frame. Secure both pins with cotter pins. (See Figure 3.)
5.Install the Break Away Slide (D) into the rear clevis of the 3-point frame as shown in illustration 4. Secure with a pin and cotter pin as shown.
Figure 2
Figure 3
DM 07-02 | Assembly Section 3-2 |
© 2004 Alamo Group Inc.
