11 12

T: 0800 0124 382 T: 0800 0124 382
INSTALLATION
INSTALLATION REQUIREMENTS
To avoid risk of injury, please take care when moving your Washer Dryer. It is heavy and we
recommend that a minimum of two people move your Washer Dryer.
To unpack your Washer Dryer and manoeuvre it to the installation area, one perso n should hold
it by the front feet and the other person at t he edge of the lid at the rear.
Your Washer Dryer measures 84.5 x 59.7 x 58.2cm and will require an installation area wi th the
space to allow the door to fully open and provide easy access to the plumbing and ele ctrical
connections.
The most suitable installation surface for your Washer Dr yer is a concrete floor as it is less
prone to vibration during the spin cycle. Soft floor sur faces such as carpets and rugs are not
suitable.
If you have to install your Washer Dryer on a wooden floor, we recommend that a wa ter-
resistant wooden base at least 30mm thick is installed. The b ase should span several joists and
be bolted down. Check for the presence of pipes and c ables before installing.
If possible, install your Washer Dryer in the corner of the room as it is of ten the most stable part
of the floor.
Do not install your Washer Dryer in rooms where temperatures b elow freezing may occur as
frozen hoses may burst or split.

REMOVAL OF TRANSIT BOLTS

The transit bolts are used to protect your Washer Dr yer from damage during transportation and
must be removed before using your Washer Dryer for the first t ime. Keep the transit bolts safe
and re-fit them if you need to transport your Washer Dr yer in the future.
The four transit bolts are located on the back of y our Washer Dryer (fig 5a).
To remove the transit bolts (4 off):
1 Remove each bolt by turning anti-clockwise with a suitable spanner (f ig 5b).
2 Pull out the remaining plastic section of each transit bolt by hand. This will require a
reasonable amount of force (fig 5c).
3 Insert the blanking caps (4 off): Push the cap into the hole unt il the four connectors click into
place. Check that the cap is flush with the Washer Dryer.
To re-fit the transit bolts (4 off) for futur e transportation:
1 Pull and remove the four plastic blanking caps.
2 Insert the plastic sections of the transit bolts in to the exposed holes.
3 Insert the bolts into the plastic sections of the tr ansit bolts and tighten with a suitable
spanner until secure.
Figure 5
a: b:
c: