71
9
MOVING AND STORING THE UNIT
Moving instructions
When moving the unit, follow the procedure below.
1Turn the power switch off and remove the power cord from the
outlet.
2Open the side cover and front cover, in that order. Remove the
TD cartridge and close the front cover and side cover, in that
order.
To open and close the side cover and front cover, and to remove the TD
cartridge, see "TD CARTRIDGE REPLACEMENT" (p.57).
3Raise the handle of the paper tray and pull the paper tray out
until it stops.
4Push the center of the pressure plate down until it locks in
place and lock the plate using the pressure plate lock which
has been stored in the front of the paper tray.
5Push the paper tray back into the unit.
6Lock the scan head locking switch (p.9).
7Close the multi-bypass tray and the paper output tray
extension, and attach the packing materials and tape which
were removed during installation of the unit. See "PREPARING
THE UNIT FOR INSTALLATION" (p.8).
8Pack the unit into the carton. See "CHECKING PACKED
COMPONENTS AND ACCESSORIES" (p.8).
Proper storage
Store the supplies in a location that is:
•clean and dry,
•at a stable temperature,
•not exposed to direct sunlight
Store paper in the wrapper and lying flat.
•Paper stored out of the wrapper or in packages standing on end may curl or get
damp, resulting in paper misfeeds.
When moving this unit, be sure to remove the TD cartridge in advance.
When shipping the unit, the scan head locking switch must be locked to
prevent shipping damage.
AL-1215_1530-1551CS.book 71 ページ ２００２年８月７日 水曜日 午前９時３４分