Sharp AR-203E operation manual Copy Flow, Turn on the unit p.13, Start copying

3 MAKING COPIES

This chapter explains basic and other copying functions.

The unit is equipped with a one-page memory buffer. This memory allows the unit to scan an original once only and make up to 99 copies. This feature improves workflow, reduces operation noise from the copier, and provides higher reliability by reducing wear and tear on the scanning mechanism.

If the unit does not function properly during use, or if a function cannot be used, see "TROUBLESHOOTING THE UNIT" (p.50).

COPY FLOW

1Make sure that paper has been loaded in the paper tray (p.8) or multi- bypass tray (p.10), and check the paper size (p.7).

If paper is not loaded, see page 8.

2 Turn on the unit (p.13).

3Place the original.

If you are using the original table, see "Using the original table" (p.15). If you are using the SPF, see "Using the SPF" (p.16).

When copying onto paper larger than A4, pull out the paper output tray extension.

4Select the copy settings.

If you wish to copy using the initial settings (p.14), proceed to the next step. To set the number of copies, see page 17.

To adjust the resolution and contrast settings, see page 17. To enlarge or reduce the copy, see page 19.

To change the tray used, see page 19.

5Start copying.

Press the start () key.

12