Sharp LC-46LB700X Supplying electric power to the antenna, Initial auto installation, Press Enter

Preparation

Supplying electric power to the antenna

When you set-up the DTV antenna for the fi rst time, or connect the antenna to a community antenna, you need to proceed to set the antenna by following this manual.

Initial auto installation

When the TV powers on for the fi rst time after purchase, the initial auto installation wizard appears. Follow the menus and make the necessary settings one after another.

Confirm the following before turning on the power

•Is the antenna cable connected?

•Is the AC cord plugged in?

1 Press POWER on the TV.

• The initial auto installation wizard appears.

2Setting the on-screen display language.

Display language settings

English

1Press DTV to access DTV mode.

2Press MENU and the MENU screen displays.

3Press c/d to select “Setup”.

4Press a/b to select “Antenna Setup-DIGITAL” and then press ENTER.

5Press a/b to select “Supply Voltage” and then press ENTER.

6Press c/d to select “On” and then press

ENTER.

Selected item	Description
On	Select “On” when your antenna is set-up
	and connected independently.
	Typical supply voltage: 5V
	Typical supply current: 50mA
Off	Select “Off” when you do not need to
	supply voltage to your antenna, i.e.
	when your antenna is connected to a
	community antenna. (The factory default
	setting of this function is “Off”.)

3Press a/b to select the desired language, and then press ENTER.

Press c/d to select “HOME” or “STORE”, and then press ENTER.

Select the location of TV.

The picture will be optimized for that location.

HOME STORE

•HOME: “STANDARD” will be the default value for the “AV MODE” setting. “Blu-ray disc Ecology” is set to “Enable”.

•STORE: “DYNAMIC (Fixed)” will be the default value for the “AV MODE” setting. If the “AV MODE” is changed, the TV will automatically switch back to “DYNAMIC (Fixed)” when there is no further change to TV setting for 30 minutes. “Blu-ray disc Ecology” is not available.

4Press ENTER.

Major Analogue Channel settings are pre-set. However, if there are any channel(s) that you cannot receive with the factory pre-sets, please perform “Auto Installation” in “Setup” section (refer chapter “Watching TV” on manual).

Digital Search

•Major Analogue Channel settings are pre-set. However, if there are any channel(s) that you cannot receive with the factory pre-sets, please perform “Auto installation” in “Setup” section. (See page 22.)

12