Sharp LC-46LB700X operation manual Reset, Download setup, Information, Identification

Appendix

Reset

If complex adjustments are made and the settings cannot be restored to normal, you can reset the settings to the factory preset values.

1Press MENU and the MENU screen displays.

2Press c/d to select “Setup”.

3Press a/b to select “Reset”, and then press

ENTER.

4If you have already set the password, enter it here.

•“Return to factory pre-settings” displays on the screen.

5Press c/d to select “Yes”, and then press

ENTER.

•“Now, TV will restart automatically. OK?” displays on the screen.

6Press c/d to select “Yes”, and then press

ENTER.

•“Now initialising...” displays on the screen and blinks.

•After the reset has completed, the power shuts off and then comes back on. The screen will have returned to its original settings.

After factory presetting,

TV will restart automatically

Now initialising...

7Press a/b to select the desired language listed on the screen, and then press ENTER.

Press c/d to select “HOME” or “STORE”, and then press ENTER.

8Press ENTER.

Major Analogue Channel settings are pre-set. However, if there are any channel(s) that you cannot receive with the factory pre-sets, please perform “Auto Installation” in “Setup” section (refer chapter “Watching TV” on manual).

Digital Search

•Major analogue channel settings are pre-set. However if there are any channel(s) that you cannot receive with the factory pre-sets, please perform “Auto installation” in “Setup” section. (See page 22.)

9The TV searches for, sort and stores all the receivable TV stations according to their settings and the connected antenna.

•To abort the initial auto installation in progress, press RETURN.

NOTE

•When the TV is in STORE mode, repeat steps 1 to 7 to change to HOME mode.

Download setup

The TV automatically determines whether a new software version is available when the TV is in standby mode.

Selected item	Description
Yes	Automatically searches for new software
	updates available when the TV is in
	standby mode.
No	Does not search for update information.
Now	Checks if there is new software
	immediately.

Downloading the software

You can select the method of update.

1If the software is updated, the confi rmation message “New download information has been detected.” appears

•If the TV receives the update service while in standby mode, a confi rmation message displays after turning on the power.

2Follow the screen prompts.

Selected item	Description
Yes	Starts downloading immediately. It takes
	approximately one hour to update. You
	cannot carry out other operations while
	downloading.
	• Cancels the download by pressing
	ENTER on the remote control unit
	when “Discontinue” is displayed on the
	screen during the update.
No	Starts downloading automatically several
	minutes after entering standby mode.

NOTE

•The TV must remain in standby mode for download. Do not turn off the power using POWER on the TV.

•Updating the software may take some time.

Information

Message list

When a new broadcast station is detected, the message is updated in the “Message list” of the “Information” menu.

Receiver report

Display reports regarding failures and changes for timer settings.

Identification

	You can check the current version of the TV software
	on the screen.
90	(BD version is Blu-ray disc Setup menu.)