Sharp LC-46LB700X Picture size settings, Watching TV Auto power-off after the end of broadcast

Watching TV

Auto power-off after the end of broadcast

You can set the TV to automatically power off in about 15 minutes after the TV goes into a state of receiving no programme signals, such as the end of a broadcast day.

1Press MENU and the MENU screen displays.

Picture size settings

Selecting the Wide Screen Signalling (WSS) picture size automatically

WSS allows a television to switch automatically among the different screen formats.

2	Press c/d to select “ECO”.
	• ECO menu displays.
3	Press a/b to select “No signal off”, and then
	press ENTER.
4	Press c/d to select “Enable”, and then press
	ENTER.

• Five minutes before the power shuts down, the

remaining time displays every minute.	1	Press MENU and the MENU screen displays.
NOTE

•“Disable” is the factory preset value.

•When a TV programme finishes, this function may not operate.

Auto power-off when there are no operations performed

You can set the TV to automatically power off when no TV operation is performed for more than 3 hours.

1Press MENU and the MENU screen displays.

2Press c/d to select “ECO”.

• ECO menu displays.

3Press a/b to select “No operation off”, and then press ENTER.

4Press a/b to select “30min.” or “3hr.”, and then press ENTER.

•Five minutes before the power shuts down, the remaining time displays every minute.

2Press c/d to select “Setup”.

3Press a/b to select “WSS”, and then press

ENTER.

4Press c/d to select “On” or “Off”, and then press ENTER.

NOTE

•Try to set WIDE mode if an image does not switch to the correct screen format. When the broadcast signal contains no WSS information, the function will not work even if enabled.

Selecting the Wide Screen Signalling (WSS) picture size manually

The WSS signal has 4:3 auto-switching that allows you to select between Panorama and Normal.

NOTE

• “Disable” is the factory preset value.

Quick start

You can reduce the TV’s start-up time after turning on the power with the remote control unit.

1Press MENU and the MENU screen displays.

1Press MENU and the MENU screen displays.

2Press c/d to select “Setup”.

3Press a/b to select “4:3 mode”, and then press ENTER.

4Press c/d to select “Panorama” or “Normal”, and then press ENTER.

2 Press c/d to select “Setup”.	WSS signal 4:3 screen
	4:3 mode “Panorama”	4:3 mode “Normal”

3Press a/b to select “Quick start”, and then press ENTER.

4Press c/d to select “On” or “Off”, and then press ENTER.

Selected item	Description
On	The TV quickly starts up from standby,
	19 W or more of power consumption is
	required during standby.
Off	Power consumption is less than 1 W.

Selected item	Description
Panorama	Wide image without side bars
Normal	Normal range keeping 4:3 or 16:9 aspect
	ratio

33