Sharp LC-65RX1X Initial auto installation, Checking signal strength and channel strength

Preparation

Initial auto installation

When the TV powers on for the fi rst time after purchase, the initial auto installation wizard appears. Follow the menus and make the necessary settings one after another.

Confirm the following before turning on the power

•Is the antenna cable connected?

•Is the AC cord plugged in?

1 Press POWER on the TV.

• The initial auto installation wizard appears.

2Setting the on-screen display language.

English

3Press a/b to select the desired language, and then press ENTER.

Checking signal strength and channel strength

If you install a DVB-T antenna for the fi rst time or relocate it, you should adjust the alignment of the antenna to receive a good reception while checking the antenna setup screen.

1Press MENU and the MENU screen displays.

2Press c/d to select “Setup”.

3Press a/b to select “Antenna Setup- DIGITAL”, and then press ENTER.

w Checking signal strength

Press a/b to select “Signal Strength”.

4Press ENTER.

Major Analogue Channel settings are pre-set. However, if there are any channel(s) that you cannot receive with the factory pre-sets, please perform “Auto Installation” in “Setup” section (refer chapter “Watching TV” on manual).

Digital Search

Supply Voltage

Signal Strength

Channel Strength

CH No.		21
Signal Strength
	Current	0	Max	0
Quality
	Current	0	Max	0

•Major Analogue Channel settings are pre-set. However, if there are any channel(s) that you cannot receive with the factory pre-sets, please perform “Auto Installation” in “Setup” section (See page 20).

5The TV searches for, sorts and stores all the receivable TV stations according to their settings and the connected antenna.

•To abort the initial auto installation in progress, press ENTER.

NOTE

•If you turn off the power on the TV after performing step 4, the initial auto installation wizard does not appear. The auto installation function allows you to execute the installation again from the Setup menu. (Page 20)

•The initial auto installation wizard will go off if you leave the TV unattended for 30 minutes before searching for channels in step 5.

w Checking channel strength

Press a/b to select “Channel strength”, and then press ENTER.

Supply Voltage	2	6	5	.	2
Signal Strength						MHz
Channel Strength	CH No.		21
	Signal Strength
	Current		0		Max	0
	Quality
	Current		0		Max	0

4Position and align the antenna so that the maximum possible values for “Signal Strength” and “Quality” are obtained.

NOTE

•The values of “Signal Strength” and “Quality” indicate when to check the appropriate alignment of the antenna.

11