Instructions for attaching a VESA compliant arm

An arm based on the VESA standard can be at- tached to the monitor. The arm must be purchased separately.

When choosing the arm to be installed please take note of the following points.

-The arm should be compatible with the VESA standard, and there must be a gap of 75mm x 75mm between the screw holes on the section to be attached.

-The arm must not fall off or break off after being attached to the monitor.

Note:

5. Attach the arm to the monitor with four screws.

-Do not overly bend the cable or add extension cords as this could lead to malfunction.

1.

Ensure that both the monitor and computer are

 

switched off.

2.

Remove the AC adapter and the RGB signal

 

cable.

3.

Press down on the stand and gently fold back the

 

monitor.

 

Be sure to completely fold the monitor back to

 

stopping point.

 

If it is attempted to install the arm while the

The screws used to attach the arm should be M4 screws with a length of 4 mm ~ 6 mm protrud- ing from the surface to be attached. Using any other kind of screw may lead to the monitor falling off or damage to the internal part of the monitor.

4 ~ 6 mm

Screw used to attach arm

Arm

Part of monitor to which arm is attached

monitor is not completely folded back, the

monitor may suddenly fall, leading to malfunction.

6.Connect the AC adapter and the RGB signal cable.

Be careful not to pinch your fingers.

4.Being careful not to damage the monitor, spread out a soft cloth and lay the monitor on it display- side down.

26

Page 26
Image 26
Sharp LL-T15G1, LL-E15G1 operation manual Instructions for attaching a Vesa compliant arm