Breville BEM800 brochure Troubleshooting

TROUBLESHOOTING

Problem	Easy Solution
Machine will	• Always ensure the speed control dial is in the “Off” position
not work when	before start.
switched “ON”	• The “thermo cut-off – Temperature Overload” protection
	device has not been activated automatically, allow more time
	for the motor to cool down.
Cannot set the	• Always ensure the speed control dial is in the “Off” position
time on the	before trying to set the count-down time.
Count-down timer.
Mixer suddenly	• The mixer has been stressed by overloading or stalling. The
switches off during	mixer will automatically activate the overload protection
mixing	button and the unit will switch itself off. When this happens
	it is recommended that the unit is switched off at the power
	outlet and unplugged. The safety devices will the be reset and
	the Breville Scraper Mixer Pro is ready to use again.
“E1” error message	• The mixer will automatically stop operating if the motor is
is flashing on the	stalled. If this occurs, the ‘E1’ error message will flash on the
count-up/down	count-up/down timer display. This is an electronic safety
timer display	feature. This is normally a result of too much ingredients
	being processed at one time. Try removing some of the
	ingredients from the bowl. To continue mixing, turn the speed
	control dial to the off position and unplug the mixer from the
	power outlet. Then plug the mixer into the power outlet and
	use as normal.
“E2” error message	• This may indicate that the motor has been stressed by
is flashing on the	overheating with excessive load. The mixer is fitted with a self-
count-up/down	resetting safety device which safeguards against overheating
timer display.	on the motor with excessive loads. If overheating occurs, the
	mixer will automatically activate the overheating protection
	device and the motor will switch itself off. When the
	overheating protection is activated, unplug the mixer from the
	power outlet for at least 15 minutes to allow the unit to cool.
	Turn the speed control dial to the “Off” position then plug the
	mixer into the power outlet and use as normal.
Noise is heard	• When ingredients are in the mixing bowl, the scraper beater
when scraper	may make a slight noise as it scrapes the sides and bottom
beater is mixing	of the bowl. This is normal and should not cause concern. Do
	not turn the mixer on with the scraper beater in place if the
	mixing bowl is empty. This will cause the scraper beater to
	make a loud noise as it scrapes the bowl.

37