(Continued)

Preset tuning

You can store up to 40 stations in memory (40 stations con- sisting of any combination of AM and FM stations you like) and recall them.

2,4 3

3

2,4

To enter stations into memory:

1 Perform steps 1 - 5 in the "Tuning" section.

2 Press the MEMORY/ENTER button.

MEMORY

3 Within 5 seconds, turn the jog dial or press the PRE- SET (X or W) button to make the preset channel number flash in the display.

Store the stations in memory, in order, starting with preset channel 1.

When is displayed, a station has already been stored in this preset number memory.

4 Within 5 seconds, press the MEMORY/ENTER button to store that station in the selected station preset number memory.

MEMORY

If the "MEMORY" and preset number indicators go out before the station is memorised, repeat the operation from step 2.

5 Repeat steps 1 - 4 to set other stations, or to change a preset station.

When a new station is stored in the selected station pre- set number memory, the contents previously memorised will be erased.

To recall a memorised station:

Turn the jog dial or press the PRESET (X or W) button for less than 0.5 seconds to select the desired station.

The stations (preset channel number, frequency and fre- quency band) which have been stored in memory will ap- pear in the display in numerical order, irrespective of the frequency bands.

Backup function:

The backup function protects all station presets for a few hours should there be a power failure or the AC power lead is re- moved from the AC socket.

Preset memory scan

The stations saved in the preset memory can be scanned automatically.

 

PRESET

CLEAR

(X W)

 

MEMORY/

 

ENTER

 

1 To scan the preset stations, press the PRESET (X or W) button for more than 0.5 seconds.

The station preset number will flash and the programmed stations will be tuned in sequentially, for 5 seconds each.

2 Press the PRESET (X or W) button again to stop the memory scan at the desired station.

Note:

When the preset memory does not have any stations stored in it, the preset memory scan will not function.

To erase the memorised station:

1 Recall the memorised station to erase by turning the jog dial or pressing the PRESET (X or W) button.

2 Press the CLEAR button.

"MEMORY" and preset number will flash.

3 Within 5 seconds, press the MEMORY/ENTER button.

4 Repeat steps 1-3 to erase other memorised stations.

To erase all memorised stations:

When the unit is in the stand-by mode, hold down the TUNER (BAND) and the MD buttons, and then press the ON/ STAND-BY button.

"PRESET CLR" will appear.

18

Page 19
Image 19
Sharp MD-MX10H operation manual Preset tuning, Preset memory scan, Clear Memory Enter