SETTING THE CLOCK
| MEMORY/ |
ENTER | |
| Jog dial |
CLOCK
●In this example, the clock is set for the
1
2 Press the CLOCK button.
6 Adjust the hour by turning the jog dial.
●When the jog dial is turned one click clockwise, the time will increase by 1 hour. When it is turned one click coun- terclockwise, the time will decrease by 1 hour.
Keep turning the jog dial to change the time continuously.
●When the
7 Press the MEMORY/ENTER button.
8 Adjust the minutes by turning the jog dial.
●When the jog dial is turned one click clockwise, the time will increase by 1 minute. When it is turned one click coun- terclockwise, the time will decrease by 1 minute.
Keep turning the jog dial to change the time continuously.
●The hour setting will not advance even if minutes advance from "59" to "00".
9 Press the MEMORY/ENTER button.
●The clock starts operating from "0" second. (Seconds are not displayed.)
3 Within 5 seconds, press the MEMORY/ENTER button.
4 Turn the jog dial to select the time display mode.
"0:00" →The
"12:00 AM" →The
"0:00 AM" →The
●Note that this can only be set when the unit is first in- stalled or it has been reset (see page 38).
5 Press the MEMORY/ENTER button.
To see the time display:
Press the CLOCK button.
●The time display will appear for about 5 seconds even in the
Note:
●The "CLOCK" will appear at the push of the CLOCK button when the AC power supply is restored after a power failure occurs or after the AC power cord is disconnected.
If this happens, follow the procedure below to change the clock time.
To change the clock time:
1Press the CLOCK button.
2Within 5 seconds, press the MEMORY/ENTER button.
3Perform steps 6 - 9 above.
To change the time display mode:
1Reset the microcomputer (see page 38).
2Perform steps 2 - 9 above.
11
