Sharp PG-D100U Basic Operation of the Projector, Connect the AC cord, Turn on the MAIN POWER

Basic Operation of the Projector

1

2

OFF

OFF ON

POWER

ON LAMP

TEMP.

2 MAIN POWER switch

1 AC cord

When the MAIN POWER is on, the POWER indicator lights red.

1. Connect the AC cord

Open the socket cover and connect the supplied AC cord to the socket.

2. Turn on the MAIN POWER

Turn the MAIN POWER switch on the side of the projec- tor. The POWER indicator lights red and the projector enters STANDBY mode.

3	Remote control
Projector
ON/OFF	ON/OFF
	ON
	OFF

POWER	When the power is on, the LAMP
	REPLACEMENT indicator flashes
	to show the operating condition of
LAMP	the lamp.
	Green:	Lamp is ready
TEMP.	Flashing green:	Warming up
	Red:	Change bulb

3. Turn on the POWER

Press the POWER ON/OFF button on the projector or the POWER ON button of the remote control.

•When the power is turned off by pressing the POWER ON/OFF button, the POWER indicator will not turn off until the fan has stopped running.

•See page 31, “Lamp/Maintenance Indicators” for details.

Notes:

•When the POWER indicator is not lit, the remote control cannot be used to operate the projector.

•If the power is turned on immediately after it has been turned off, it may take a short while before the lamp turns on. (During this period the LAMP REPLACEMENT indicator flashes.)

•After the projector is unpacked and turned on for the first time, a slight odor may be emitted from the exhaust fan. This odor will soon disappear with use.

4

4. E-ZOOM Function

This projector has an E-ZOOM mode which enlarges the display when inputting an image of less than 800 ⋅ 600 dots in size. The E-ZOOM button of the remote control is used to operate E-ZOOM function.

See page 26, “E-ZOOM Function” for details.

E-ZOOM (ON)	E-ZOOM (OFF)	Notes:
		• E-ZOOM function does not operate with monochrome images
		or in SVGA (800 ⋅ 600), Mac 16" (832 ⋅ 624), NTSC, PAL or
		SECAM INPUT mode.
		• The picture size differs in RGB, NTSC, PAL and SECAM
		INPUT modes.

E-20