Sharp VL-WD250U operation manual As S E T T E

Warning Indicators

If a warning indicator appears on the screen, follow the specified instructions.

Operation References

Displayed for the first			Displayed after		Description of warning
3 seconds			3 seconds
I NS E R T					There is no video cassette in the camcorder.
A C AS S E T T E .					Insert a cassette (see page 10).
E J E C T	THE		E J E C T THE		The video cassette is defective and should be
CAS SE T T E .			CAS SE T T E .		removed (see page 10).
CASSE T T E		NOT	P RO T E C T . T A B		The erasure protect tab on the video cassette
					has been slid to the record-protect position,
RE CORDA BL E.
					preventing recording (see page 65).
THE TAPE			T A PE E ND		The tape is about to end. Prepare a new
ENDS	SOON.				cassette (see page 10).
CHANGE	THE		T APE END		The tape has reached the end. Replace it with a
CAS SE T T E .					new cassette (see page 10).
BAT T ERY		I S			The battery is almost depleted. Replace it with a
TOO	LOW.				fully charged battery pack (see page 8).
					Dew has formed inside the camcorder. Wait for
					a few hours until the dew disappears (see
DEW			DEW		page 67).
					About 10 seconds after this warning appears,
					the camcorder automatically turns off.
					The video heads are clogged and should be
					cleaned (see page 68).
					The fluorescent lamp behind the LCD monitor is
L AMP			L AMP		close to the end of its service life. Call your local
					authorized Sharp dealer to have it replaced.
					When the vertical rotation of the LCD monitor is
					between 135° and 180° in CAMERA mode, all
					warnings will be indicated by F displayed in
					the center of the viewfinder and the LCD
					screen. To check the type of warning, rotate the
					monitor back to within 135°.
Note:
•N indicates a flashing display.				6