Setting up the Projector Network Environment
4 The TCP/IP setting screen ap- pears, ready for network settings for the projector.
Items | Setting example / Remarks |
DHCP | Select “ON” or “OFF” to determine |
Client | whether to use DHCP Client. |
IP Address | You can set this item when “DHCP |
| Client” is set to “OFF”. |
| Factory default setting: 192.168.150.2 |
| Enter an IP address appropriate |
| for the network. |
Subnet | You can set this item when “DHCP |
Mask | Client” is set to “OFF”. |
| Factory default setting: 255.255.255.0 |
| Set the subnet mask to the same |
| as that of the computer and |
| equipment on the network. |
Default | You can set this item when “DHCP |
Gateway | Client” is set to “OFF”. |
| Factory default setting: 0.0.0.0 |
| * When not in use, set to “0.0.0.0”. |
DNS | Factory default setting: 0.0.0.0 |
Server | * When not in use, set to “0.0.0.0”. |
Note
•Confirm the existing network’s segment (IP address group) to avoid setting an IP ad- dress that duplicates the IP addresses of other network equipment or computers. If “192.168.150.2” is not used in the network
having an IP address of “192.168.150.XXX”, you don’t have to change the projector IP address.
•For details about each setting, consult your network administrator.
5
6
Click the “Apply” button.
The set values appear. Confirm that the values are set properly, and then click the “Confirm” but- ton.
•Close the browser.
•This completes the network settings.
•After setting items, wait for 10 seconds and then
•Change the IP address of the setting computer back to its original address, which you have noted down in Step
-23
